Electronics Forum | Wed Jun 29 19:25:02 EDT 2005 | matjen
I found a place that exchanges old nozzles for new ones; thanks for the inputs though.
Electronics Forum | Wed Jun 29 09:05:38 EDT 2005 | jdengler
Try http://www.smtresearch.com/ But the price is not much cheaper than new ones.
Electronics Forum | Thu Jun 30 10:11:47 EDT 2005 | Stefan
Here is another one: http://www.cotinc.com/product_range.htm
Electronics Forum | Tue Jun 28 19:56:20 EDT 2005 | matjen
I am in the process of searching for anyone that does repair on fuji cp6 nozzles .7 & 1.0 mainly, We have an abundance of bent and broken nozzles that I would like to get repaired rather than throwing out so if anyone has information on this please
Electronics Forum | Tue Nov 19 12:34:33 EST 2013 | jimmyboz
I am not trying to be critical but, you didn't even say Fuji CP-6 problem. There are CP-6, CP-642, and CP-643 machines, are asking 2 model as 642? Anyway, slow the cam speed down in the proper to 40 or 50%. If the problem goes away check the mainte
Electronics Forum | Fri May 30 09:50:04 EDT 2008 | jdengler
Another sticky issue is that if you use after market nozzles especially mixed in with Fuji nozzles the Anti-Marking Illumination Disks can be different enough that the vision system will reject nozzles. Jerry
Electronics Forum | Fri May 30 09:53:19 EDT 2008 | cyber_wolf
"Another sticky issue is that if you use after market nozzles especially mixed in with Fuji nozzles the Anti-Marking Illumination Disks can be different enough that the vision system will reject nozzles. Jerry " Thats what I meant when I said they
Electronics Forum | Fri May 30 11:58:16 EDT 2008 | fredc
The right paper incorrectly applied can be a problem also. I have seen it on even new Fuji nozzles with the illumination disk bunched up on one side of the tube with a gap on the opposite side.
Electronics Forum | Wed Jun 29 03:47:12 EDT 2005 | fastek
I'm confused. Aren't Fuji nozzles like $20 each? Why bother? I would hope you understand that a nozzle not properly repaired could cause $50 worth of rework in about a minute after you installed it. Stepping over dimes to pick up pennies comes to min
Electronics Forum | Wed Jun 29 03:23:10 EDT 2005 | dougs
We used to use a company in the uk that did this, we stopped as the results were never that good, i think the company stopped offering the service as well as no-one else wanted to have their nozzles repaired, it's best to get new nozzles in and make
