Electronics Forum | Mon Mar 24 15:20:15 EDT 2014 | kojotssss
Hello for all People's .I have a question. I have a problems with backup pin placement.When x/y robot tried to set up pins: we got a problem- X=-0.200 and y=-0.880 To my mind ther are a problem with air cylinder and axis.Any solutions?! can you c
Electronics Forum | Thu Sep 03 02:25:07 EDT 2020 | thanhctran30
Check the backup battery. My KE2020 experienced the same symptoms and its was caused by bad backup battery. I unplugs the power source from the battery and plugs direct to the AC outlet and the machine working fine. Ordered 2 replacement batteries on
Electronics Forum | Wed Aug 17 08:36:15 EDT 2011 | rway
It's unlikely that this is the root cause. The battery may be dead, but the entire board is dead. This battery is most likely used for data retention for volatile memory as a battery backup.
Electronics Forum | Fri Dec 22 09:47:18 EST 2006 | realchunks
Check your battery back up if you have it. If I remember correctly, you may have to manually switch your wiring to by pass a dead battery back-up.
Electronics Forum | Sun Jan 18 17:40:40 EST 2015 | rowsail
I have a NOVASTAR 1200 with a ProcessSentry(tm) controller. The battery backup battery went flat and thus it refuses to do any "work" because it is requesting the oven be "tuned". To enter the "Tune" menu a password is required. Does anyone know t
Electronics Forum | Wed Feb 17 13:15:51 EST 2010 | jdengler
It turned out to be the battery in the CP-1 PLC. Replaced the battery and we are back up and running.
Electronics Forum | Tue Nov 14 09:43:10 EST 2000 | jason
Hi, I have a question about charging up batteries. I have two batteries in series, they are NiMH PCB mounted rechargable batteries that are used for battery backups etc. I want to be able to recharge these batteries, so I wont have to buy new ones
Electronics Forum | Wed Jan 05 14:53:59 EST 2011 | cwhite30
I got it working. The computer backup battery did indeed die. I obtained the bios settings from the manufacturer. Thanks
Electronics Forum | Mon Jan 31 08:59:38 EST 2011 | kennypascarelli
I have an oven that now wants me to tune and can't do anything until I enter a password. The big problem is I don't know the password. Any way to find it or bypass it. Figured it out, the machine has a battery back-up and it needed to be replaced.
Electronics Forum | Wed May 11 10:40:10 EDT 2005 | pr
Are any of you shutting down all manufacturing machines when a thunderstorm approaches? My company is/has been doing this forever and tell me it's to protect the machines. I could see doing it to protect boards in the machines (except we have battery
