Electronics Forum | Fri Sep 01 19:54:31 EDT 2017 | tmennink
What was the outcome OrHorti after baking some? In the end we went with a different machine (Fuji NXT) which was able to get the leds out of the reel. After switching we still face a loss of about 0.5% but it is acceptable for now.
Electronics Forum | Wed Aug 02 05:27:00 EDT 2017 | tmennink
We did this test, we opened the tape and turned it upside down, indeed some leds were staying inside the tape. We will try placing them next week with a fuji NXT line. We also contacted the manufacturer, apparently heat perhaps during transport coul
Electronics Forum | Tue Jul 05 16:58:00 EDT 2022 | jdengler
When these old Fuji's do weird things I usually try a reset start. Many times that fixes the issue. Make sure you have a valid proper file before you try it. Jerry
Electronics Forum | Mon Jul 04 13:43:38 EDT 2022 | richardcargill
is it a specific part you're having the problem with, or does the fault manifest on a number of different ones ?
Electronics Forum | Mon Jul 04 13:56:23 EDT 2022 | madisreivik
Actually its one part. I had an idea to test some completely different, pre-defined component which has been placed on that machine before. Do You suspect there is a diabolical shape parameter somewhere ? :)
Electronics Forum | Tue Jul 05 07:02:26 EDT 2022 | richardcargill
Possibly, yeah. Or the wrong sized nozzle ( or chipped or blocked ) We have problems occasionally with larger components and vacuum levels. If the component has a makers 'circular void' on the pick up surface then the actual pick coordinates have to
Electronics Forum | Tue Jul 05 07:16:35 EDT 2022 | madisreivik
The problem is that.. 1) it always drops at the same location and the vacuum led shows that machine indeed turns the vacuum off ! 2) the same nozzle picks up much heavier components from other feeders without problems 3) the MTU component - i turn
Electronics Forum | Fri Jul 01 17:52:45 EDT 2022 | madisreivik
Hello ! I got very strange problem with Fuji IP3 (year 2000 something) MTU picks up the part and puts it on carrier conveyor Conveyor moves the part into main machine. All the positions are correct, centers etc.. But now, the main machine pick th
Electronics Forum | Tue Jul 05 17:09:40 EDT 2022 | madisreivik
PROBLEM SOLVED :) ! I messed with parameters, then started to check hardware again. and.... There are 2 transport position on the carrier 1) vacuum 2) mech clamp Both have fiber position sensor which shows the status When there is component, the
Electronics Forum | Thu Jun 13 08:53:25 EDT 2013 | markhoch
Ahhh yes. The infamous round rubber belts used on the Fuji CP2's and CP3's. :) I remember fondly using a pair of dykes and a Bic Lighter to make my belt repairs. Does anyone know if these are still available from Fuji? You may be able to find repl
