Electronics Forum | Fri Sep 18 03:02:07 EDT 2015 | linux
Hello everyone. Need urgent help with our cp6, when front door is open servo amp alarm comes up, this error will clear using the reset button. Has anyone any idea how I would go about fixing this issue.
Electronics Forum | Thu Jul 11 14:19:04 EDT 2013 | nicodj77
Hi, I'd google it and found these Maint. Manual for Fuji CP43 http://210.29.224.4/smt/newssb/fs/311.pdf Operation Manual for Fuji CP43 http://www.winsmt.com/down/006.pdf Hope it helps! Nick
Electronics Forum | Thu Jun 27 14:56:05 EDT 2013 | kdc45
Purchased 2 used Fuji CP43's and did not receive manuals with them. Have been using CP42 manuals to write procedures and looking for jigs for the vision systems to calibrate them. However, I cannot find the jigs with the part #'s that are in the CP42
Electronics Forum | Thu Jan 20 06:01:23 EST 2005 | mhe
Hi guys, we are facing a problem - d axis servo overflow in our fuji cp-4. Can anyone please suggest some remedy? thanks deepak
Electronics Forum | Sun Aug 29 09:03:00 EDT 1999 | Kenny Chew
Looking to purchases: GL-2, GL5, GL541E CP4-3, CP-6 IP-2, IP-3
Electronics Forum | Sat Jan 29 12:01:32 EST 2011 | jts142
hi i am having problems with a cp 643 when i run in auto it errors unloading a board with the x axis servo interlock error but if i hit sequence end stop so that it stops after every board it runs and unloads perfectly. Any hints or suggestions we ha
Electronics Forum | Thu Aug 26 12:55:44 EDT 2010 | fuji
My spec book shows 10 NL/min
Electronics Forum | Fri Apr 23 02:15:36 EDT 2010 | smellew
Hi Rodrigo, Have you fixed your CP65? do you need some help? llew
Electronics Forum | Fri Apr 16 17:44:40 EDT 2010 | rodrigo
We're still trying to fix a C-axis overflow error in our CP-65. I was swapping servo boards and one of them started to blinks a 2 on the LED single digit display and the machine didn't boot up. I replaced the servo board with a spare we bought on eba
Electronics Forum | Fri Mar 22 03:19:43 EDT 2019 | bukas
well, in video shown it looks like #1 motor drives head #1 upwards but does not detect home sensor being triggered. and then you get timeout error, head not being able to reach the position ( machine not registering it has reached position). since yo
.gif)
.gif)
