Electronics Forum | Fri Apr 15 15:04:02 EDT 2005 | lyrtech
Hi, Sometimes we have the following error: " TABLE BASE NOT GOOD ". In the manual, it says that we have to check the cylinder and other parts around the table. This is not very specific. Can anyone helps us with some hints? Thank you
Electronics Forum | Fri Apr 15 16:02:26 EDT 2005 | jdengler
ING, If my memory is correct: -This is from the large air cylinder below the X/Y table moving slow or not getting down all of the way. -The air cylinder has a sensor for when it's down all of the way. - This sensor could be bad but most of the t
Electronics Forum | Mon Sep 10 12:18:05 EDT 2012 | benreben
Hi, what's the feeding sensor error? the sensor for cartrige or the sensor on cylinder up of feeder? manual is step mode? if you have the number of error at screen,i have the fuji error code help. in step mode the machine is very slowly,maybe the a
Electronics Forum | Sun Sep 11 07:16:31 EDT 2011 | smellew
We are using Fuji CP iv-3 and keep getting > "Nozzle size alarm and Nozzle position error." I > was wondering what is wrong and how do I fix > these errors? > > Thanks > We are using Fuji CP iv-3 and keep getting > "Nozzle size alarm and Nozzl
Electronics Forum | Tue Apr 19 05:42:13 EDT 2005 | woodglass
There's two sensors at the rear of the XY table. Make sure that these are functioning correctly. You can view their states in the I/O map. The solenoid which actuates the table base up/down air cylinder is also at the rear of the table, to the left o
Electronics Forum | Wed Feb 01 00:10:32 EST 2006 | kent
Are you seeing this problem with the nozzles after an error stop? Well check station 15 confirm nozzle clutch origin. It will cause this problem. If you rotate a shaft (with the machine stopped) 45 degrees and start you will get return theta off and
Electronics Forum | Tue Oct 05 15:39:35 EDT 2010 | daxman
Hi Steve, I don't know if there are a lot of people who can decrypt the trace data. I think the manual mentions sending it to fuji for analysis. Maybe that would be something worth checking into. Regarding the Mecca check mode: I don't know if it wi
| 1 |
