Electronics Forum | Fri Apr 14 13:39:07 EDT 2006 | cyber_wolf
Does the unit come with all of the master jigs and tapes, or do you have to purchase them seperate ?
Electronics Forum | Wed Jul 26 11:14:50 EDT 2006 | FredC
Are these covers repacements for the tape guides? If so in retipping many thousands of cp6 nozzles we see that the window in the tape guide is often miscentered and the needle tip rubs on the same place every time it picks. I expect the miscentered g
Electronics Forum | Wed Apr 02 12:44:15 EDT 2008 | cyber_wolf
Does anyone know of an after market source for the E-clips that hold the tape covers on CP and IP feeders. I am sure I can dig something up I just figured I'd ask ya'all first. Fuji PN: S1021A
Electronics Forum | Fri Apr 14 19:51:53 EDT 2006 | ____
Master Jigs and tape are separate. The "All in One" jig is around $12k just so you know.
Electronics Forum | Wed Jul 26 14:40:28 EDT 2006 | FredC
I just checked a hand full of scrap nozzles and the scuffing is usually on the right or left of the needle. If you have the cross pin facing you and looking down on the nozzle most of the scuffing or wear was on the left side, sometimes on both sides
Electronics Forum | Wed Jan 08 14:18:34 EST 2003 | soupatech
I have run across a resistor array whose tape has a 2mm pitch. Is there a way to modify a Fuji CP3 8x4 feeder to make it 8x2? Or do I need to purchace new feeders?
Electronics Forum | Tue Jan 14 15:38:28 EST 2003 | fujispares
Hi, CP3 will have trouble placing 0603 parts - I wouldn`t use a CP3 for these parts - A CP4 will be more suitable. A older CP4 feeder will fit and function on a CP3.
Electronics Forum | Fri Feb 13 10:13:56 EST 1998 | Simon Washer
Has anyone running the cp4-3 feeders (MC type) in 8 by 4 td flavour seen excessive wear on the aluminum body caused by the tape leaf cover and tape leaf retaining clip?? These are the black anodised aluminum feeders (new type) that we run on all cp4
Electronics Forum | Tue Jan 14 11:02:59 EST 2003 | soupatech
I found a feeder with a 2mm pitch and was told that although it was made for the CP4, it would work with the CP3. Before we throw out a thousand bucks, has anyone had experience loading parts off of a 2mm pitch tape with the CP3? The part is a 1.6
Electronics Forum | Fri Apr 10 06:21:08 EDT 1998 | Ben Salisbury
| Has anyone running the cp4-3 feeders (MC type) in 8 by | 4 td flavour seen excessive wear on the aluminum body | caused by the tape leaf cover and tape leaf retaining | clip?? Sorry for the delay in posting to this one... I have in fact seen this w
winsouce.jpg)