Electronics Forum | Wed Jul 26 11:14:50 EDT 2006 | FredC
Are these covers repacements for the tape guides? If so in retipping many thousands of cp6 nozzles we see that the window in the tape guide is often miscentered and the needle tip rubs on the same place every time it picks. I expect the miscentered g
Electronics Forum | Wed Jul 26 14:40:28 EDT 2006 | FredC
I just checked a hand full of scrap nozzles and the scuffing is usually on the right or left of the needle. If you have the cross pin facing you and looking down on the nozzle most of the scuffing or wear was on the left side, sometimes on both sides
Electronics Forum | Thu Apr 23 18:40:35 EDT 2009 | nickh
Do any of you fine people have any suggestions on how to align the Fuji CP3 tape leaf sensor? The little mirrors are out of alignment, any ideas how to get them back? Thanks!
Electronics Forum | Sat Apr 25 02:46:18 EDT 2009 | smellew
FYI SME offers a replacement Tape leaf detection system which covers the whole range of FUJI CP4-CP7 machines.its also very reasonably priced. It doesn't use Fibre Sensors or mirrors. it only has 1 adjustment which is height via Eccentric screw. even
Electronics Forum | Mon Apr 27 11:04:59 EDT 2009 | nickh
Thanks for the help Jerry
Electronics Forum | Mon Oct 22 10:54:48 EDT 2007 | mulder0990
What type of feeder storage carts do you use for your feeders? I have many of the Fuji CP-6 racks, but I have found the few Mossman Tebbs racks mor useful and safer for the feeders. I am constantly fixing damaged tape leaf covers from operators not
Electronics Forum | Thu Mar 01 16:39:29 EST 2012 | triadelectronics
Our company is going to attempt to place 0201 components using our Fuji CP4-3 with the upgraded SMD3 vision system. Count On Tools is providing the 0.4 mm nozzles and we are using our 8mmX2mm feeders with the 0.7mm tape leaf (if it works at all we w
Electronics Forum | Fri Feb 13 10:13:56 EST 1998 | Simon Washer
Has anyone running the cp4-3 feeders (MC type) in 8 by 4 td flavour seen excessive wear on the aluminum body caused by the tape leaf cover and tape leaf retaining clip?? These are the black anodised aluminum feeders (new type) that we run on all cp4
Electronics Forum | Thu Jun 24 20:14:52 EDT 2004 | Alan
I know your frustration. CP6 feeders are notorious for this issue. They have always been an issue. You have probably went through the "change spring, change tape leaf, change component reel, place peeler tape over two rollers instead of three" scenar
Electronics Forum | Fri Apr 24 07:27:28 EDT 2009 | jdengler
Hi Nick, I took a feeder that was broken and modified it. I glued shims in place to set the sensor height with. I glued a block of metal to work as a stop for the Y axis. Then for the rotation I use a piece of paper to see were the emitter is poi
winsouce.jpg)
