Electronics Forum | Thu Oct 29 23:49:32 EST 1998 | Thomas Clift
I am currently in the process of rebuilding and maintaining a never-ending supply of tape-feeders for Fuji CPIII and IPII (Fuji and Hover-Davis). I have seen the videos and am not having all that much trouble, but I would like to compare notes with s
Electronics Forum | Fri Oct 30 18:51:07 EST 1998 | phillip hunter
| I am currently in the process of rebuilding and maintaining a never-ending supply of tape-feeders for Fuji CPIII and IPII (Fuji and Hover-Davis). I have seen the videos and am not having all that much trouble, but I would like to compare notes with
Electronics Forum | Tue Nov 03 12:21:53 EST 1998 | phillip hunter
| Thanks for your reply. | I am interested in knowing about maintenance schedules and levels. I'm wondering how to know if I must replace a part. What part? What type of lubrication (for Fuji). Etc. | My company is small in terms of number of lines
Electronics Forum | Fri Nov 20 23:00:07 EST 1998 | David Lombard
| | Thanks for your reply. | | I am interested in knowing about maintenance schedules and levels. I'm wondering how to know if I must replace a part. What part? What type of lubrication (for Fuji). Etc. | | My company is small in terms of number of
Electronics Forum | Mon Nov 02 17:14:52 EST 1998 | Thomas Clift
Thanks for your reply. I am interested in knowing about maintenance schedules and levels. I'm wondering how to know if I must replace a part. What part? What type of lubrication (for Fuji). Etc. My company is small in terms of number of lines and th
Electronics Forum | Thu Oct 30 21:06:20 EDT 2008 | ashley
Hello mickd, For Fuji practice, the primary tooling hole preferably be 5mm from the edge of the PCB (lower right hand corner). This is the reference X0, Y0 co-ordinates in the Fuji program where placing co-ordinates going LEFT will be -ve value & go
Electronics Forum | Fri Oct 31 15:20:38 EDT 2008 | mmjm_1099
The following attachment I hope is useful.
Electronics Forum | Thu Oct 30 16:53:38 EDT 2008 | m79d
Hi all I am going to get a board laid out which will be done on a fuji cp43, could the experts please tell me what should be the width of the tooling strips? size/placement of the fiducials? I also want to use the pin to hold the board, where exactl
Electronics Forum | Sat Nov 01 04:12:53 EDT 2008 | ashley
Hello mickd, The Fiducial Marks are normally etched along the vertical side of the PCB, therefore it will not be block by the XY table clamping rails. p.s. try to have a Shiny & Round Fiducial Mark as recommended by Fuji....so that you need not inp
Electronics Forum | Mon Nov 03 07:47:47 EST 2008 | jdengler
mickd, I prefer a rail of 7.62mm (0.300"). This alows for the tooling pins and fiducials without any trouble and minimizes the waste. A fiducial of 1mm round with a 1mm clear area around it. Jerry