Electronics Forum | Wed Jul 26 12:22:28 EDT 2006 | cyber_wolf
The new universal guide replaces .7 - 1.8 mm tape covers. Fuji no longer makes the slitted type tape covers. How can the tape guide be mis-centered ?
Electronics Forum | Wed Jul 26 11:14:50 EDT 2006 | FredC
Are these covers repacements for the tape guides? If so in retipping many thousands of cp6 nozzles we see that the window in the tape guide is often miscentered and the needle tip rubs on the same place every time it picks. I expect the miscentered g
Electronics Forum | Wed Jul 26 14:40:28 EDT 2006 | FredC
I just checked a hand full of scrap nozzles and the scuffing is usually on the right or left of the needle. If you have the cross pin facing you and looking down on the nozzle most of the scuffing or wear was on the left side, sometimes on both sides
Electronics Forum | Fri Jun 16 00:45:19 EDT 2006 | Richard Robins-Bird
Not all splicing tapes require the use of specialist tooling or splicing plates to make a join. Please see wwww.fujismt.com where a complete range of SMT splicing tapes (Joint Tapes) can be found for use with chip mounters such as Assembleon, Europla
Electronics Forum | Sun Jul 31 23:28:32 EDT 2005 | saiwong
Fuji will not sell the reel by itself. also, you need to change the tape guide to 0.7 in order to place the 0402. Tape guide cost you almost a hundred bucks. I don't think it is a good idea to modify the feeder.
| 1 |
.gif)
winsouce.jpg)