Electronics Forum | Wed Jul 26 11:14:50 EDT 2006 | FredC
Are these covers repacements for the tape guides? If so in retipping many thousands of cp6 nozzles we see that the window in the tape guide is often miscentered and the needle tip rubs on the same place every time it picks. I expect the miscentered g
Electronics Forum | Wed Jul 26 14:40:28 EDT 2006 | FredC
I just checked a hand full of scrap nozzles and the scuffing is usually on the right or left of the needle. If you have the cross pin facing you and looking down on the nozzle most of the scuffing or wear was on the left side, sometimes on both sides
Electronics Forum | Sat Jul 03 13:49:36 EDT 1999 | JohnW
50% reduction in time. One draw back, the availability of feeders... You need 280 feeders max to change over a max capacity of 140 feeder machine (or a variance of a product mix vs. part numbers); then there's 8mm, 12mm, 16mm, sticks feeders that c
Electronics Forum | Sat Jul 03 19:24:25 EDT 1999 | JohnW
50% reduction in time. One draw back, the availability of feeders... You need 280 feeders max to change over a max capacity of 140 feeder machine (or a variance of a product mix vs. part numbers); then there's 8mm, 12mm, 16mm, sticks feeders that c
Electronics Forum | Sat Jul 03 18:14:03 EDT 1999 | Earl Moon
50% reduction in time. One draw back, the availability of feeders... You need 280 feeders max to change over a max capacity of 140 feeder machine (or a variance of a product mix vs. part numbers); then there's 8mm, 12mm, 16mm, sticks feeders that c
| 1 |
