Electronics Forum | Thu Aug 25 09:56:39 EDT 2005 | cyber_wolf
Can anyone tell me what he overall height of a CP6 board support/backup pin is supposed to be? They don't sell the back up pins as an assembly. It looks like you have to buy them piece by piece and set the height yourself. Thanks
Electronics Forum | Thu Aug 25 14:41:06 EDT 2005 | jdengler
The height varies with board thickness. The top of the board is always held at the same height so as the board thickness increases the pin height decreases. Jerry
Electronics Forum | Tue Feb 01 16:56:46 EST 2022 | rstellema
Hello all, I have a couple of old FUJI CP-6 SMT placement machines that are operating with very old PCMCIA Flash Memory cards. I would like to insure that I have back-ups should the memory cards fail. I assume that I would need a support USB reader/w
Electronics Forum | Thu Aug 25 11:15:16 EDT 2005 | dougs
do you mean the board support pins? generally anytime i've set these up i've just set the height as i've went, i put the pin under the board, with the board clamped, and move it up until it touches the board and set it there. you just need to make
Electronics Forum | Fri Jul 17 19:43:20 EDT 2009 | fujiphil
Have you eliminated the hardware N.G.? Check the connection for the rear door. If the connection are ok, try to bypass the key. short the two wires for the rear door. If the rear door problem is corrected, check the rear door switch physically. Reg
Electronics Forum | Fri Nov 10 10:39:43 EST 2000 | omar_verdugo
Hello Eva. I was using Fujicam 1.1 and i had a problem with the theta is in the shape library for example all the drawings are on 0 degress like a in the part data and all that work fine with the anothers machines like a cp6, but when i use a ip2 i m
| 1 |
.png)
