Electronics Forum | Thu Jun 11 06:57:22 EDT 2015 | cyber_wolf
Linux, The amount of error that you are describing is about the thickness of a human hair. Unless you are placing 0201's I can't understand why .12 is an issue. There are many factors that can effect placement accuracy on a CP6 For instance: 1. M
Electronics Forum | Thu Jun 11 03:59:00 EDT 2015 | linux
Sr Tech. Thanks for reply, We don't have the same issue with other cp6, was wondering was there anything else we could check?. Thanks again.
Electronics Forum | Thu Jun 30 05:22:11 EDT 2005 | dougs
it's been a while since i've worked on a CP6 but there is a sensor around the X-Y table ( near the back, it's not attached to the table, it sits just below the turret area )that tells the machine if there is a board there, i think you need to set thi
Electronics Forum | Sun Aug 30 15:32:33 EDT 2009 | jimmyboz
most fuji error codes are 8 digits, A21E is 2100A21E, it is a report from the MCS that transmission has failed (we knew that) Hit control E from the main screen of the MCS, there should be another error reported from the cp6, ie. 1101000 is x data ou
Electronics Forum | Wed Jun 29 03:23:10 EDT 2005 | dougs
We used to use a company in the uk that did this, we stopped as the results were never that good, i think the company stopped offering the service as well as no-one else wanted to have their nozzles repaired, it's best to get new nozzles in and make
Electronics Forum | Fri Jul 08 10:11:44 EDT 2005 | Luke Mittur
Hello When the table goes back to loading position, it checks for the avaialbility of the board. It is possible that there is a component right under the PCB confirm sensor and the sensor is not able to recognise the board, so it unclamps . No
Electronics Forum | Tue Jul 12 03:57:55 EDT 2005 | woodglass
Hi, In the CP6 propers, there are values: PCB Check Position X, & PCB Check Position Y. These are the servo counts that the X/Y table moves to when checking if a PCB exists on the table. Your sensor does not detect a PCB, probably because when checki
Electronics Forum | Sun Aug 29 09:03:00 EDT 1999 | Kenny Chew
Looking to purchases: GL-2, GL5, GL541E CP4-3, CP-6 IP-2, IP-3
Electronics Forum | Sun Aug 29 11:33:38 EDT 1999 | Malcolm Montanjees
| | fuji gp, cp642e, ip3 and other | | Dear Sir, please explain what you mean by GP, are you referring to Fujiu GSP printers? if so, what models are you looking for. We have GSP3-5000 and GSP3-4000 avaiable for immedate sale at $25,000 each. FOB Nor
Electronics Forum | Fri Sep 18 03:02:07 EDT 2015 | linux
Hello everyone. Need urgent help with our cp6, when front door is open servo amp alarm comes up, this error will clear using the reset button. Has anyone any idea how I would go about fixing this issue.
