Electronics Forum | Tue Feb 15 10:38:30 EST 2005 | Dougs
I've seen this before. I had a CP6 doing this for a while, replaced the nozzle springs with ones wound the opposite way from the fuji ones. replaced the springs with these and never had the problem again. you can get them from Ritchie precision eng
Electronics Forum | Wed Mar 02 10:49:45 EST 2005 | Dave Erbst
Try checking your Z height and also make sure that they are cleaned regularly. If the Z height is off your will be pressing your nozzles into the holders thereby causing them to bind up inside the holder. Replace the springs periodically since they d
Electronics Forum | Tue May 04 22:45:58 EDT 2004 | alwil
I want to find out if we can place 0201 components using a Fuji CP6-E 4000. If this is possible, do we require any upgrades to the machine. Is anyone doing this at present with this type of CP6. If so, what size of nozzle and feeder type is being use
Electronics Forum | Thu Mar 03 11:10:20 EST 2005 | Dougs
I'm telling you i've bought the nozzles wound the wrong way and it helped, no more probs with nozzles sticking, i'd tried buying fuji nozzles, checked all my component heights, set Z0 properly, checked shaft heights, set up st1, etc etc but the new s
Electronics Forum | Wed Jul 12 17:05:22 EDT 2017 | rodrigo
Hi all, Our Fuji cp6 woke up with a bad power supply (ps) this morning. The ps is one of two 24vdc (Corsel P300E-24). There is one inside the cabinet and one on the door where the cpu card is. The bad one is the one inside the cabinet. So we had anot
Electronics Forum | Mon Jan 21 08:47:36 EST 2002 | pr
The nozzle shafts are different (and windmill/ head), cutter blades and assy. are different, that's all I can think of off the top of my head. Also slightly slower than a CP64. I believe the 65 and 65000 are the same.
Electronics Forum | Thu May 03 13:37:07 EDT 2007 | cyber_wolf
We occasionally have this problem where the nozzles peck little holes in the component overlay tape causing it to break. It only happens on universal tape covers. We see it on our CP4 and CP6 machines. Has anyone else experienced this ?
Electronics Forum | Thu Jun 14 16:31:38 EDT 2007 | aj
I concur Chunks ! A simple test to carry out is the Z0 height check across the board, with particular attention to the area of the board you are having problems. You should at least see the nozzle touch the board , ideally press the board slightly.
Electronics Forum | Thu Jan 26 09:13:22 EST 2006 | dougs
i didn't see anything about setting shaft height there, only a procedure for measuring nozzle length. just out of interest, whats the cost difference between a re-tipped nozzle and a new one from fuji? And how much is one of those shaft jigs?
Electronics Forum | Tue Mar 25 02:53:25 EDT 2008 | vincentng68
We sell fuji spare parts. We have the nozzle holder. If you want, please e-mail me.
