Electronics Forum | Wed Jun 10 10:38:51 EDT 2015 | cyber_wolf
The published Fuji CP6 placing accuracy specification is plus/minus .1mm I would say that your machine is running just fine.
Electronics Forum | Thu Jun 11 07:26:20 EDT 2015 | linux
Think you right, not enough to be worried about. Thanks for all your help.
Electronics Forum | Sun Jun 07 19:16:54 EDT 2015 | linux
Hello everyone, I'm looking for help with placement issue on our cp6 Fuji. On occasion we have to adjust co ordinates on the x and y axis usually about 0.12mm. Ball screw was replaced did not fix issue. Anything else we could try. Thanks everyone
Electronics Forum | Thu Jun 11 06:57:22 EDT 2015 | cyber_wolf
Linux, The amount of error that you are describing is about the thickness of a human hair. Unless you are placing 0201's I can't understand why .12 is an issue. There are many factors that can effect placement accuracy on a CP6 For instance: 1. M
Electronics Forum | Thu Jun 11 03:59:00 EDT 2015 | linux
Sr Tech. Thanks for reply, We don't have the same issue with other cp6, was wondering was there anything else we could check?. Thanks again.
Electronics Forum | Wed Jun 29 19:33:12 EDT 2005 | matjen
After the machine stops for any reason when restarted the z table goes to loader position comes up then goes back down and re-reads the fiducials, only one machine does this but we are losing valuable cycle time after every part change. We have Fuji
Electronics Forum | Tue Nov 03 12:21:53 EST 1998 | phillip hunter
| Thanks for your reply. | I am interested in knowing about maintenance schedules and levels. I'm wondering how to know if I must replace a part. What part? What type of lubrication (for Fuji). Etc. | My company is small in terms of number of lines
Electronics Forum | Fri Nov 20 23:00:07 EST 1998 | David Lombard
| | Thanks for your reply. | | I am interested in knowing about maintenance schedules and levels. I'm wondering how to know if I must replace a part. What part? What type of lubrication (for Fuji). Etc. | | My company is small in terms of number of
Electronics Forum | Wed Apr 12 06:40:11 EDT 2006 | aj
All, I continuosly have reliability issues when placing a SOT363 device. I have Fuji CP6 and CP4 placement machines. The part data has been analysed down to the finest detail but it is still hard to maintain any consistency. Anyone else have simi
Electronics Forum | Tue Jul 03 09:57:25 EDT 2001 | johnw
Hi guys I am looking for any info on cpk values IE fcp6, fip2,fip3 What are the variables to consider for placement times and part sizes. Cheers
.gif)
