Electronics Forum | Sun Jul 11 21:10:27 EDT 2010 | fujiphil
First, check the sensors for 17th and 19th station....tune the sensor amplifier if necessary. Then, check the dogs on the nozzle holders... If the above, items are ok... check the 13th station clutch engagement. Calibrate if necessary... fujiphil
Electronics Forum | Fri Jul 09 23:45:22 EDT 2010 | dman97
I have a CP642 machine that always gives me a Station 17 or Station 19 nozzle error when the machine selects the 2.5mm 3.7mm or 5.0mm nozzles. It always throws an unknown nozzle station 17 error after all the heads have switched to the above mention
Electronics Forum | Tue Nov 19 12:34:33 EST 2013 | jimmyboz
I am not trying to be critical but, you didn't even say Fuji CP-6 problem. There are CP-6, CP-642, and CP-643 machines, are asking 2 model as 642? Anyway, slow the cam speed down in the proper to 40 or 50%. If the problem goes away check the mainte
Electronics Forum | Wed Nov 20 10:21:09 EST 2013 | cyber_wolf
Station 17 and 19 errors are almost always caused by dirty clutches or bad sensor dogs. My guess would be bad sensor dogs in this case if it only does it on certain jobs. The reason it happens on those jobs is because there are nozzles being indexed
Electronics Forum | Wed Jul 14 09:08:30 EDT 2010 | cyber_wolf
Dirty clutches can also cause this issue.
Electronics Forum | Tue Jul 13 10:51:55 EDT 2010 | muarty
Sounds pretty much like the sensors/amplifiers need tuned on your machine. It is a fairly straightforward exercise to do this. The sensors basically look at the back of the chucks to determine which nozzle is in the lowest position and therefore whic
Electronics Forum | Tue Jul 13 21:05:04 EDT 2010 | dman97
Thanks for the replies. Indeed the amplifier needed to be tuned. I have recalibrated it and all is working as it should. Thanks for the advice.
Electronics Forum | Mon Oct 19 14:24:09 EDT 1998 | Robert Cass
Desperately seeking station 13 belt for Fuji CP6
Electronics Forum | Wed Jun 27 09:17:43 EDT 2007 | gregf912
I have set the PQ with the CP6 station jigs. It is dialed in to 0.02mm of zero. I also checked station 5.
Electronics Forum | Thu Mar 30 12:13:10 EST 2006 | Tech
Obviously you are not as experienced as you think so I will help you out a bit.You are correct on the size of the wrench. I was trying to recall from memory but the wrench size is 8mm. The odd size I recalled came from the other side of the wrench th
