Electronics Forum | Mon Jun 19 13:53:18 EDT 2006 | choppy
Does it reach the home sensor ? Is it activated ?
Electronics Forum | Mon Jun 19 10:10:18 EDT 2006 | rmitchell
Hi, Our CP6-5 has a Z overflow error when trying to zero set. The table moves in X and Y and almost zeros prior to the Z overflow. Servo Amp? Rob
Electronics Forum | Wed Jun 21 09:23:28 EDT 2006 | rmitchell
problem solved. Some PCB table support pins were jammed down in the table preventing the Z axis from lowering all the way. The intial error mesage was x and y servo, but the real error was the z axis overflow. Rob
Electronics Forum | Tue May 12 12:28:22 EDT 1998 | Rin Or
| I'm in the process of doing an evaluation fora big board machine. My choices are Universal HSP 4791 and Fuji CP6-5. | Has anyone one a subjective evaluation on both machines? If so what was the outcome, abd experiences since installing the selected
Electronics Forum | Tue May 12 12:27:52 EDT 1998 | Rin Or
| I'm in the process of doing an evaluation fora big board machine. My choices are Universal HSP 4791 and Fuji CP6-5. | Has anyone one a subjective evaluation on both machines? If so what was the outcome, abd experiences since installing the selected
Electronics Forum | Wed Jun 21 04:11:31 EDT 2006 | daxman
Are you familar with using the mecca mode on Fuji machines? There is a procedure I can take you through that will check the servo amp and allow you to adjust it. Is your machine useable at all? can you get it to pass zero set? If you can, view your s
Electronics Forum | Tue May 12 08:56:54 EDT 1998 | Process Engineer
I'm in the process of doing an evaluation fora big board machine. My choices are Universal HSP 4791 and Fuji CP6-5. Has anyone one a subjective evaluation on both machines? If so what was the outcome, abd experiences since installing the selected mac
Electronics Forum | Fri May 29 10:21:06 EDT 1998 | Dave
| I'm in the process of doing an evaluation fora big board machine. My choices are Universal HSP 4791 and Fuji CP6-5. | Has anyone one a subjective evaluation on both machines? If so what was the outcome, abd experiences since installing the selected
Electronics Forum | Tue Jun 01 16:12:49 EDT 2004 | gregf912
The 10k rebuild does not need to be applied every 3-4 months as previosly stated. A cp machine that is running 100% of the time on a 24/7 basis will tack up 10k hours in 12.4 months. Now we all know that this is impossible due to parts shortages, pro
| 1 |
