Electronics Forum | Tue Jan 29 14:30:38 EST 2019 | younes
CP642 WORK in WHETH NO ERROR in ONE PROGRAME.IF I CHANGE IT ERROR STATION 19
Electronics Forum | Sun Jul 11 21:10:27 EDT 2010 | fujiphil
First, check the sensors for 17th and 19th station....tune the sensor amplifier if necessary. Then, check the dogs on the nozzle holders... If the above, items are ok... check the 13th station clutch engagement. Calibrate if necessary... fujiphil
Electronics Forum | Tue Feb 19 09:19:01 EST 2002 | Kent
We have been placing 0201 in our production using both CP642 and CP643 since last year. But it was necessary to upgraded a narrow view camera to recognize 0201 for CP642. Since then, the placement of 0201 is really reliable.
Electronics Forum | Fri Jul 09 23:45:22 EDT 2010 | dman97
I have a CP642 machine that always gives me a Station 17 or Station 19 nozzle error when the machine selects the 2.5mm 3.7mm or 5.0mm nozzles. It always throws an unknown nozzle station 17 error after all the heads have switched to the above mention
Electronics Forum | Wed Jul 14 09:08:30 EDT 2010 | cyber_wolf
Dirty clutches can also cause this issue.
Electronics Forum | Fri Jul 19 07:37:22 EDT 2019 | BigFuji642
Anyone got some ideas of what my issue could be?
Electronics Forum | Fri Jul 19 11:11:38 EDT 2019 | dman97
Have you imported the proper data into flexa yet?
Electronics Forum | Wed Jun 27 09:17:43 EDT 2007 | gregf912
I have set the PQ with the CP6 station jigs. It is dialed in to 0.02mm of zero. I also checked station 5.
Electronics Forum | Thu May 19 12:16:48 EDT 2005 | beto_30
In this plant we have some lines with this configuration: Dek infinity - CP642 - CP642 - FIP3 - GSM - Vitronics and our averrage in change over is 60 min. It is possible that we will have a new one smt line, with Dek - My15 - My15 - Vitronics.
Electronics Forum | Tue Jul 13 10:51:55 EDT 2010 | muarty
Sounds pretty much like the sensors/amplifiers need tuned on your machine. It is a fairly straightforward exercise to do this. The sensors basically look at the back of the chucks to determine which nozzle is in the lowest position and therefore whic