Electronics Forum | Wed Sep 30 06:22:23 EDT 2015 | mervin
MPMENG, Thank you so much for taking the time to help. The machine has Y snuggers and flippers. The Pcb is loading in the center all the time. The driver cards look fine there is no obvious faults on them or partially burned. The machine was not in
Electronics Forum | Fri Oct 26 11:29:41 EDT 2001 | kaopsahl
I have two DEK 288s set up in our shop, we used to use a Fuji GSP_III. I could not possibly say enough good things about the DEKs - they are incredible. The only real complaint I have with them is that if an error pops up that locks up the software -
Electronics Forum | Sun Aug 28 23:53:58 EDT 2016 | aemery
I don't think there is a camera off message in the software, but I might be wrong. So I am making a bit of an assumption here that you didn't have a displayed image and your error was a fiducial not found error. I am also wondering if you decided to
Electronics Forum | Thu Aug 05 20:33:48 EDT 2004 | Dhanish
The machine type is Fuji CP6.We have major issues with Network Resistor placement.The equipment guys often feedback there is a problem with nozzle and feeders.What will happened to the part if the Thickness data in the Part Data does not match the Pa
Electronics Forum | Thu Apr 30 16:13:38 EDT 1998 | Chrys
| | | | | Hello - | | | I am interested in obtaining information on the possibility of integrating a Vision Inspection System with an SMT line. I am aware of systems which may be used to gather placement data and such, but are there any systems whic
Electronics Forum | Tue May 13 08:47:38 EDT 2008 | locostpp
Yes, this is a good point and really only time will tell just how reliable such a machine becomes. What I'm aiming for is to simplify and reduce the number of sub-assemblies. For example we are building the camera/vision processor and lighting into
Electronics Forum | Fri Aug 07 09:53:12 EDT 2009 | kpm135
The Z-axis Drive card on our MPM UP2000 HiE fried. We replaced it with a new card, setting all the jumpers to match the old card. After that we had to recalibrate the Z-axis and the snugger height but the problem is that the camera is now too close t
Electronics Forum | Tue Apr 27 16:42:18 EDT 2010 | m79d
Hi jepoy + a very frazzled man thanks for your suggestions,here is how it went:- I found a couple of these VM1710 boards and tried one and still nothing. I really wanted to see if power was getting to the camera and anything coming out. I was loo
Electronics Forum | Wed Jun 02 16:33:08 EDT 2004 | davem
Fuji is the best, but there are other alternatives besides Quad. If you really want to look at Fuji, take a peek at their XP142E series. With "Vision processing on the fly" and a "Mini Turret Head" with 12 placement nozzles it should fit your needs n
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723