Electronics Forum | Wed Sep 12 10:49:46 EDT 2012 | cyber_wolf
Sounds like the feed cylinder sensor. Its a air cylinder hooked to the tape feeder advancing mechanism in the rear of the machine. Go into the I/O and make sure the sensor is changing state when you flag it.
Electronics Forum | Fri May 28 05:24:28 EDT 2004 | johnjohn
Guys I am looking for alternative spares for Fuji machines Especially the dad air cylinders s2085h.From Fuji they are 8-10 week lead time this is a nightmare do any of you guys know of alternative sourcing JOHN
Electronics Forum | Fri Apr 15 16:02:26 EDT 2005 | jdengler
ING, If my memory is correct: -This is from the large air cylinder below the X/Y table moving slow or not getting down all of the way. -The air cylinder has a sensor for when it's down all of the way. - This sensor could be bad but most of the t
Electronics Forum | Fri Apr 15 15:04:02 EDT 2005 | lyrtech
Hi, Sometimes we have the following error: " TABLE BASE NOT GOOD ". In the manual, it says that we have to check the cylinder and other parts around the table. This is not very specific. Can anyone helps us with some hints? Thank you
Electronics Forum | Wed Sep 12 11:55:18 EDT 2012 | mtech88
Sr. Tech: I will check the air cylinder at the rear and see what position when the machine stop. Thanks David
Electronics Forum | Fri Jun 13 13:19:54 EDT 2014 | cyber_wolf
That little cylinder comes apart. Sometimes they get gummed up and need to be taken apart and cleaned.If it does not make the sensor in time, it pops an error up.
Electronics Forum | Thu Jan 10 15:32:54 EST 2008 | jdengler
A long time ago, in a place far, far away, I would test Fuji IP machines without the MFU's installed. They have a mechanical switch on the machine so it knows when a MFU is present. But what normally catches everyone is that the locking air cylin
Electronics Forum | Mon Sep 10 12:18:05 EDT 2012 | benreben
Hi, what's the feeding sensor error? the sensor for cartrige or the sensor on cylinder up of feeder? manual is step mode? if you have the number of error at screen,i have the fuji error code help. in step mode the machine is very slowly,maybe the a
Electronics Forum | Thu Oct 30 09:23:34 EDT 2008 | jwolvans
Hi, Rob. Does the table appear to hang up, then suddenly let go? If so, check the alignment of all four conveyor rail guide blocks, especially if the clamping rails have been recently removed for maintenance. After that, check the piston assembly t
Electronics Forum | Mon Mar 24 15:20:15 EDT 2014 | kojotssss
Hello for all People's .I have a question. I have a problems with backup pin placement.When x/y robot tried to set up pins: we got a problem- X=-0.200 and y=-0.880 To my mind ther are a problem with air cylinder and axis.Any solutions?! can you c
.png)
