Electronics Forum | Sun Aug 30 15:32:33 EDT 2009 | jimmyboz
most fuji error codes are 8 digits, A21E is 2100A21E, it is a report from the MCS that transmission has failed (we knew that) Hit control E from the main screen of the MCS, there should be another error reported from the cp6, ie. 1101000 is x data ou
Electronics Forum | Wed Feb 17 12:19:41 EST 2010 | cyber_wolf
Remove the HIMV-134 card. Unscrew the piggy back memory card and re-seat it. See if that helps.
Electronics Forum | Thu Sep 09 13:41:43 EDT 2021 | fernsure
Tried suggested solution in manual to no avail. Reseated every connector we could get to. Has anyone run into this error, and found a solution? This error does not allow me to ignore this head and use the other two. Thanks Fern
Electronics Forum | Sun Aug 18 21:06:45 EDT 2019 | dman97
Based on the fuji error codes, It says that the ARCNET cable is disconnected. Make sure that all cables from this module are connected to the QP.
Electronics Forum | Fri Apr 23 02:15:36 EDT 2010 | smellew
Hi Rodrigo, Have you fixed your CP65? do you need some help? llew
Electronics Forum | Fri Apr 16 17:44:40 EDT 2010 | rodrigo
We're still trying to fix a C-axis overflow error in our CP-65. I was swapping servo boards and one of them started to blinks a 2 on the LED single digit display and the machine didn't boot up. I replaced the servo board with a spare we bought on eba
Electronics Forum | Mon May 18 10:41:46 EDT 2015 | leeg
Over Current is normally when something is jammed.
Electronics Forum | Sat Nov 07 18:38:32 EST 2020 | enzik
Hello to all, The Fuji GSP III screen printer was working well yesterday. This morning, the machine turned on and the display screen was showing nothing. I went to the back of the machine and reset one of the VM1152A. The display screen is now showi
Electronics Forum | Fri Mar 02 14:00:39 EST 2018 | magergar
I have a problem with my fuji machine, it was working and then this error code appear: INTL SRV creation error Error Code:12037A20 and this shows every time on boot and doesn't let me do anything. what should I check?
Electronics Forum | Tue Jun 20 19:12:41 EDT 2023 | madisreivik
Hello all ! FUJI IP3 starts up, makes zero setting OK But if I start AUTO mode, it gives error -------------------------------------------------------------------------------- Code 11082010 UsedBy MTU3,MTU4,MTU5 Display Usable Proper Data has
