Electronics Forum | Sun Aug 30 15:32:33 EDT 2009 | jimmyboz
most fuji error codes are 8 digits, A21E is 2100A21E, it is a report from the MCS that transmission has failed (we knew that) Hit control E from the main screen of the MCS, there should be another error reported from the cp6, ie. 1101000 is x data ou
Electronics Forum | Tue Feb 12 11:26:31 EST 2019 | aldrich17
Does anyone have any info. on an "E869" error code on a Phillips Topaz X SMT machine. Error screen shows "Nozzle down limit sensor is off in A-table YV100X:N2323 YV100XT:n2223 Please check sensor and remove to the cause of this sensor being off.
Electronics Forum | Tue Feb 12 12:32:45 EST 2019 | aldrich17
Your response is helpful to a point. But unfortunately i can not confirm where the sensor is as i do not know what the A-table is. But i have checked sensors that i know of and one was not giving off a signal and fixed that issue. But now i am experi
Electronics Forum | Wed Aug 12 18:06:33 EDT 2015 | bnorton
Here's the end of Logicomm capture on Force COMM2 where it starts the Lantern system not active messages. Couldn't get attach to work. Startup and earlier .ldx file loading omitted ulLoadTasks(): Opening the RFS pseudo device driver ... ulLoadTas
Electronics Forum | Sun Aug 18 21:06:45 EDT 2019 | dman97
Based on the fuji error codes, It says that the ARCNET cable is disconnected. Make sure that all cables from this module are connected to the QP.
Electronics Forum | Fri Apr 23 02:15:36 EDT 2010 | smellew
Hi Rodrigo, Have you fixed your CP65? do you need some help? llew
Electronics Forum | Tue Nov 15 00:33:42 EST 2022 | frankchan
That is right, air pressure would be a higher level of malfunction and reported on the main screen, maybe also try maintenance of the head, cleaned up and oiled them, anyway I'm speaking of experience based on the old days when I using the Fuji serie
Electronics Forum | Fri Apr 16 17:44:40 EDT 2010 | rodrigo
We're still trying to fix a C-axis overflow error in our CP-65. I was swapping servo boards and one of them started to blinks a 2 on the LED single digit display and the machine didn't boot up. I replaced the servo board with a spare we bought on eba
Electronics Forum | Sat Nov 07 18:38:32 EST 2020 | enzik
Hello to all, The Fuji GSP III screen printer was working well yesterday. This morning, the machine turned on and the display screen was showing nothing. I went to the back of the machine and reset one of the VM1152A. The display screen is now showi
Electronics Forum | Fri Mar 02 14:00:39 EST 2018 | magergar
I have a problem with my fuji machine, it was working and then this error code appear: INTL SRV creation error Error Code:12037A20 and this shows every time on boot and doesn't let me do anything. what should I check?
