Electronics Forum | Mon Jul 14 11:09:59 EDT 2003 | samaniegocesar
Hello to all. I have problems with IP1 Fuji machine, the machine was working properly and suddenly appear the erroc code 000C error task 0028 and error address F92228A0, I turn off and On again, I erase the memory but I have the same prblem, I can n
Electronics Forum | Tue Jul 15 17:30:38 EDT 2003 | ServGuy
00c is a hardware interuption Addr F92228A0 is out of the card rack, meaning probably the CPU or memory PCB is out of control. Swap the 1st and or last card in the card rack with another machine or from spares.
Electronics Forum | Sat Jan 20 17:41:11 EST 2007 | bvdb
Hoping someone can help us. Our Fuji IP-1 won't boot up unless we disconnect the 25 pin RS232 connector that runs to the MCS16/F programming computer. It doesn't matter if the 9 pin connector on the other end of the cable is plugged into the MCS16/
Electronics Forum | Sat Aug 22 10:25:11 EDT 1998 | Ben Salisbury
| We are using PCBs of CEM3 Material with bare copper fiducials. The whole | board is of bare copper with a lacquer coating (Coats brother S2974). | The fiducials are of 1 mm diameter bare copper. we use Panasert MV2F as | well as Fuji CP4-3. In bo
| 1 |
