Electronics Forum | Tue Aug 24 17:47:50 EDT 2010 | smtmax
I'm looking for CP6 fuji feeder. 16mm x 12mm (KO=8.3mm) 24mm x 20mm (KO=10.9mm) Please help! Thanks!
Electronics Forum | Fri Nov 05 22:45:04 EDT 2010 | wingding
Does anyone know where to but parts for Hover Davis feeders. I need a 18 ½ x 1/8 inch drive belt for a Fuji feeder.
Electronics Forum | Tue Mar 11 16:24:12 EDT 2014 | sumote
Does anyone have a copy of the feeder repair/maintenance for the CP6 and IP3 feeders? I need the ones that have exploded views with part numbers. I have had them in a previous life so I know they exist. If someone has a pdf file they could sen
Electronics Forum | Fri Feb 13 10:13:56 EST 1998 | Simon Washer
Has anyone running the cp4-3 feeders (MC type) in 8 by 4 td flavour seen excessive wear on the aluminum body caused by the tape leaf cover and tape leaf retaining clip?? These are the black anodised aluminum feeders (new type) that we run on all cp4
Electronics Forum | Wed Jun 04 22:52:32 EDT 2003 | hwatali
Now we are in urgent to buy 1.FUJI CP6-4000 or CP6-5000 for 3 sets;2.FUJI CP643E for 2 sets;3.CP6 8��2 and CP6 8��4 paper feeder. If you can supply these to me,pls contact me asap.
Electronics Forum | Wed Mar 21 11:38:54 EDT 2007 | aj
Hi All, Can anyone advise supplier for the above mentioned parts ? Type 1 & Type 2 i.e. for SO8 & SO16 type components. Or even better a drawing of each. aj...
Electronics Forum | Wed Oct 24 12:41:36 EDT 2007 | resource
You may pl. check for Fuji CP6 feeders parts & calibration jig at http://www.smtexpert.com
Electronics Forum | Fri Dec 21 00:06:55 EST 2007 | nhantruong
If you want to use fuji CP6 machine, you have to buy the the fuji flexa software.Because the old software from fuji (MCS or F4G) they are not support anymore. In the flexa software you can make top and bottom side in the same program, you can move th
Electronics Forum | Thu Aug 05 20:33:48 EDT 2004 | Dhanish
The machine type is Fuji CP6.We have major issues with Network Resistor placement.The equipment guys often feedback there is a problem with nozzle and feeders.What will happened to the part if the Thickness data in the Part Data does not match the Pa
Electronics Forum | Wed Jun 12 18:33:57 EDT 2019 | dman97
No Fuji support? CP6 series or Aimex 3?
.gif)
