Electronics Forum | Fri Feb 19 03:50:34 EST 1999 | Steve
Hi Brent, Fuji has a solution to solve your problem. The solution Fuji has is called "Independent Function" and this function keeps working rest of module even though one module stops due to parts run out. But this function requires hardware modifica
Electronics Forum | Fri Feb 19 03:51:04 EST 1999 | Steve
Hi Brent, Fuji has a solution to solve your problem. The solution Fuji has is called "Independent Function" and this function keeps working rest of module even though one module stops due to parts run out. But this function requires hardware modifica
Electronics Forum | Wed Jan 19 13:30:37 EST 2011 | bvdb
The user manual says: Cause: A stick feeder part shuttle is in the advanced position where it could interfere with the nozzle. Remedy: Press the [I/O] function key and retract the part shuttle. I don't have a stick feeder. I tried resetting the I
Electronics Forum | Thu Jan 20 07:58:46 EST 2011 | jdengler
Hi Bert, Take all feeders off of the machine. Do a reset start (hold reset switch in while powering up the machine). This will flush the memory so you will need to load PROPER, STATUS, PROGRAM. If it still does it you may have a short in a feede
Electronics Forum | Sun Jan 23 00:57:23 EST 2011 | bvdb
Hi Jerry, Happy New Year. Thanks for your suggestions. You were on the right track because I remembered that one of the last things that happened before the error message started showing up was that I cut and removed the empty tape from the back o
Electronics Forum | Thu Mar 30 23:30:19 EST 2006 | smtuser1234
Call Fuji HA HA
Electronics Forum | Fri Oct 25 11:21:35 EDT 2019 | slthomas
What's to stop you from programming the board as a single assembly?
Electronics Forum | Mon Aug 25 11:43:30 EDT 2014 | fuji_user_2014
Looking for information on how to stop our Fuji from picking up parts in advance for the next board at the in carrier. In other words, how can we stop the machine from picking up parts before reading fiducials on a board without adding a skip mark t
Electronics Forum | Fri Jul 09 17:52:43 EDT 2021 | glasscake
Hello, I have a Topaz-X that is losing its R origin as it runs. The issue can be seen in the following test: Set the machine to ignore vacuum/ignore alignment and have no feeders in the machine also set the nozzles all to fixed. I run a servo orig
Electronics Forum | Fri Jul 12 14:35:03 EDT 2002 | jax
BGA Clamp...... Sounds to technical to me! Not sure about what is needed for installing on IP2, although I am pretty sure it can be done. I have no pic to give. Stop working with FUJI about 5 years ago.
.gif)
