Electronics Forum | Fri Jul 19 10:45:55 EDT 2013 | kdc45
Have a Fuji IP-2 and the MTU has a servo alarm. There are three servo amp cards and the middle card is showing a 1 on the LED display. Does anyone know what this indicates? Also, can you tell me which axis this card is for? We do not have an advanced
Electronics Forum | Wed Jun 21 04:11:31 EDT 2006 | daxman
Are you familar with using the mecca mode on Fuji machines? There is a procedure I can take you through that will check the servo amp and allow you to adjust it. Is your machine useable at all? can you get it to pass zero set? If you can, view your s
Electronics Forum | Fri Mar 02 18:44:43 EST 2018 | magergar
At boot there is an alarm that I can't get rid off Servo Alarm FRQ AXIS Servo Overflow I tried to calibrate it in mecha mode but the same error doesn't let me, it's there something I can do?
Electronics Forum | Fri May 06 15:15:19 EDT 2005 | lyrtech
Hi, I have an INTERMITENT error on my FUJI IP-2 that cause to me many headaches. The error is " SERVO NOT GOOD". In the books, it means that it is relative to servo amplifier. But I can't assume that is the problem because sometimes the machine wor
Electronics Forum | Thu Sep 15 10:25:13 EDT 2005 | lyrtech
Hi, this morning we got a "servo alarm MTU" on our FUJI IP-2. On a servopack, I see an " Over Current" error. what does it mean? I don't know hoe to check that. Can anyone help me? Thanks a lot.
Electronics Forum | Mon Mar 09 17:42:56 EDT 2009 | smellew
ok Please power on the machine & confirmed that M1CP 2 is ok this is the breaker for the 35V & check M1cp1 now look at the drawings at address 1011 & check the axis ready relays Z1 11CS3x 151-GB Closed is ok if open see address 5402 Z1 servo amp is f
Electronics Forum | Tue Sep 21 18:46:24 EDT 2010 | slwolbert
Greetings: > > I am having 'Check Servo' issues > with an FCP 2 4000. It will zero set but given a > few minutes afterwards, the check servo alarm > sounds. > > At times the X/Y table will 'coast' > back to beginning position, like the power
Electronics Forum | Tue Feb 14 06:43:15 EST 2023 | vasu278
Hello guys Iam upgrading my assembly line and i have all the spares of fuji CP-43 which include servos and motors any one intersted please contact me at email- vasuprasad20@yahoo.com
Electronics Forum | Sat Sep 11 08:19:54 EDT 2010 | slwolbert
Greetings: I am having 'Check Servo' issues with an FCP 2 4000. It will zero set but given a few minutes afterwards, the check servo alarm sounds. At times the X/Y table will 'coast' back to beginning position, like the power has been cut to the
Electronics Forum | Mon Mar 09 15:40:32 EDT 2009 | smellew
Rodrigo, Is your machine IP2 or IP2E? if you still have the problem contact me direct, and i will take you through the Schematics. Llew Llew@SurfaceMountEngineering.com
winsouce.jpg)