Electronics Forum | Wed Nov 03 12:57:28 EDT 2010 | adrianam
I need some help with the following alarm appeared on Fuji FCP4-3 : ,,Servo Amplifier alarm on X, Y, C, Z axis". When I push the reset button, remain ,,Servo Amplifier Alarm on D, F theta axis". All the sensors and solenoid it were checked and is OK
Electronics Forum | Wed Nov 03 14:44:45 EDT 2010 | aj
have you checked your power supplies are all giving correct outputs?
Electronics Forum | Thu Nov 04 02:14:19 EDT 2010 | adriana
Yes, we are checked all power supplies and is OK! Many thanks!
Electronics Forum | Thu Nov 04 07:05:25 EDT 2010 | aj
happy days os
Electronics Forum | Wed Mar 07 14:55:13 EST 2018 | cyber_wolf
In my experience that error almost always indicates a bad amplifier.
Electronics Forum | Sun Jul 09 03:05:14 EDT 2000 | Ben
Hi Hermie, Did you perform a Servo-zero-adjustment and Gain calibration on the amplifier after replaced it ? This is necessary fine turning when replacing the amplifier. You had better ask Fuji service center for the procedure. Hope this help you.
Electronics Forum | Thu Oct 04 00:01:59 EDT 2018 | gaintstar
Flason SMT FUJI Pick and Place Machine: http://www.flason-smt.com/product/FUJI-Chip-Mounter-SMT-spare-parts-A10395-Fiber-Amplifier.html http://www.flason-smt.com/product/FUJI-Chip-Mounter-SMT-spare-parts-Amplifier-A1038t.html http://www.flason-smt.co
Electronics Forum | Fri May 06 15:15:19 EDT 2005 | lyrtech
Hi, I have an INTERMITENT error on my FUJI IP-2 that cause to me many headaches. The error is " SERVO NOT GOOD". In the books, it means that it is relative to servo amplifier. But I can't assume that is the problem because sometimes the machine wor
Electronics Forum | Sat Nov 19 18:35:39 EST 2011 | johndoe0222
We have an old Fuji GSP III-4000 we just changed the fiber sensor on the in-bound and outbound of the printer. The problem we are having now is the board would only go midway the table and it would go up. It does not even reach the main stopper and t
Electronics Forum | Sun Jul 11 21:10:27 EDT 2010 | fujiphil
First, check the sensors for 17th and 19th station....tune the sensor amplifier if necessary. Then, check the dogs on the nozzle holders... If the above, items are ok... check the 13th station clutch engagement. Calibrate if necessary... fujiphil
winsouce.jpg)