Electronics Forum | Mon Oct 19 14:24:09 EDT 1998 | Robert Cass
Desperately seeking station 13 belt for Fuji CP6
Electronics Forum | Mon Oct 06 18:24:34 EDT 2003 | pjc
what type of belt is it and what material is it? round belt, flat belt, etc... if its from a PCB transport conveyor or other PCB handling system, I recommend you contact the OEM. I have spliced belts before- rubber round belt off old Fuji loader and
Electronics Forum | Tue Aug 11 15:58:10 EDT 2020 | gilbe12586
Looking for FUJI CDC-4200-2 conveyor manual, belts, and bearings.
Electronics Forum | Fri Jul 22 10:30:43 EDT 2005 | Frank
I haven't heard of a meter like that. Consult Fuji for a recommended supplier if it is so special. The meter from Gates has a very sensitive microphone, so you tap (or strum) the belt and the vibration is heard and converted to Hz. If you want to
Electronics Forum | Thu Jul 22 07:30:21 EDT 2010 | nitronica1
does anyone know where I can get replacement conveyor/drive belts for a Fuji/astro pcb 0.5m conveyor? pref from the UK or europe the length of the belts are approx 630mm and 6mm wide, flat with bumps on bottom side
Electronics Forum | Thu Jun 13 08:53:25 EDT 2013 | markhoch
Ahhh yes. The infamous round rubber belts used on the Fuji CP2's and CP3's. :) I remember fondly using a pair of dykes and a Bic Lighter to make my belt repairs. Does anyone know if these are still available from Fuji? You may be able to find repl
Electronics Forum | Wed Dec 20 17:00:29 EST 2006 | aj
Have you contactd your Fuji Engineer for advise. I would really look at the z-axis belt setup before investing that sort of money. We had the exact problem here and that is all it was. aj...
Electronics Forum | Thu Jul 21 14:05:19 EDT 2005 | cyber_wolf
Dave, I think I worded my post poorly. I am not sure if "tuning fork type" is the correct terminology. The instrument I am looking for usually has a hand held unit connected to a device that resembles a small tuning fork. As a matter of fact, I thi
Electronics Forum | Mon Feb 26 12:19:01 EST 2001 | Gene
Hello John, I'm also looking for options to place BGA's with center arrays on our IP2. You mentioned a belt feeder. Are you referring to a retrofit unit? I'm not aware of a belt feeder for the IP2, but would like to hear more about it. Thanks
Electronics Forum | Fri Sep 15 03:19:07 EDT 2006 | bvdb
We've been running our Fuji IP-1 fine placement machine at 50% speed for the last few months because some of the cogged belts had cracks in them. The belts have been replaced and we're now enjoying 80% of full speed. Is there any reason not to cran
.gif)
winsouce.jpg)