Electronics Forum | Fri Feb 22 10:46:04 EST 2008 | mulder0990
Yes, we have. We do have one machine that can place the 0201 parts. I have bought some 0.4mm tape leaf covers and replaced the 0.7mm covers on some CP6 0802 feeders. I calibrate the feeders as tight as I can and make sure the feeders that we use a
Electronics Forum | Fri Aug 25 11:29:09 EDT 2006 | mika
Thanks all for Your input. The thing is that we want to avoid to go in to the pattern program and change the height in the middle of running a board. For ex. We start a product, feeders are loaded in advance in the feeder preparation area, operator
Electronics Forum | Wed Feb 17 22:55:25 EST 1999 | Dave Kalen
| | SMT Mfg. Equipment: Fuji CP-6/IP-3 - but please all hi-speed chip placer users input are appreciated !! | | | | The company that I work for is a C/M which offers both consignment but mostly turnkey work. I am currently running 3 Fuji lines. All
Electronics Forum | Mon Jan 22 13:02:10 EST 2007 | shap
We are looking at replacing our aging 4790 for something. We are replacing our GSM1 with an Advantis. We are a prototype shop and do runs of 5 to 30 normally and once in a while a run of 300. So we are looking for flexibility and ease of set up.
Electronics Forum | Mon Apr 28 11:52:28 EDT 2003 | hruiz
Thanks for your responses, as gregp says, one hour in changeover is not good when you run only 10 panels, we alredy do from 10 panels to 2500 boards per run, depends on the product, we already have a pre-kitted area mounted in their respective feeder
Electronics Forum | Thu Jun 24 07:22:19 EDT 2004 | cyber_wolf
I know I have posed this question before, but I would like to open this discussion again. We do several change overs through the course of three shifts on our CP642 line. When we start a new job, we have tons of tape feeder overlay problems.(The over
Electronics Forum | Fri Oct 26 02:12:35 EDT 2007 | jola
Hello. In a stupid way I'm glad not to be alone in the feeder jungle. We have the same ammount of feeders with a mix of Fuji and Panasonic high spped feeders as the main problem. The way we do it at the moment is that we have marked up all with a num
Electronics Forum | Fri Jun 14 13:19:15 EDT 2002 | mjabure
The first question is, is this a high mix, low volume environment or vice versa? If it's the former then Kens solution is something you might want to look into. Depending on your feeder set up you might check to see if your operators have been traine
Electronics Forum | Sun Jan 31 14:34:50 EST 1999 | Dean
| SMT Mfg. Equipment: Fuji CP-6/IP-3 - but please all hi-speed chip placer users input are appreciated !! | | The company that I work for is a C/M which offers both consignment but mostly turnkey work. I am currently running 3 Fuji lines. All parts
Electronics Forum | Mon Feb 01 17:48:36 EST 1999 | E.
| | SMT Mfg. Equipment: Fuji CP-6/IP-3 - but please all hi-speed chip placer users input are appreciated !! | | | | The company that I work for is a C/M which offers both consignment but mostly turnkey work. I am currently running 3 Fuji lines. All
winsouce.jpg)