Electronics Forum | Wed Jul 16 10:55:08 EDT 2003 | stepheno
You might want to check your input power. It is never "clean" but you might have too many spikes and transients. I've seen line monitors used and it was an eye opener how much noise there was on the input power. If you had a CPU go, you might want
Electronics Forum | Wed Nov 09 05:12:43 EST 2011 | bobpan
Motor error 4 is an error that is caused by the machine not reaching a position in a timely matter. Usually its in the x/y axis but also could be z. If you have cleared the mod codes (function 35 shift 7) the machine should home. Usually this problem
Electronics Forum | Thu Feb 02 20:48:07 EST 2006 | ____
I would like to start a new post regarding fuji > NXT machine. What do you think about the machine > as far as the servicing of the machine goes. I am > so used to the older machines such as : CP,IP, > and QP. Those machines at least give you som
Electronics Forum | Thu Mar 25 21:46:29 EST 1999 | C4 GSM GURU
| | Hey, all you Pro's out there I am looking for someone that has worked with the Universal FlexJet. We have been Beta testing one for a couple of months now and are having problems with interfacing optimization software with it. I would
Electronics Forum | Sat Apr 28 21:13:11 EDT 2018 | stephenj37824
So lots of quotes and research later we have eliminated a few added a few to our choices lol. So it looks like we will be doing a decent volume now (due to our other board supplier letting us down as well). Roughly 4-5 million leds/connectors per mon
Electronics Forum | Tue Sep 29 09:39:02 EDT 2015 | rgduval
Hey, David, For service, check out 4TechUSA over in Detroit. It's not Chicago, but, you're closer to Detroit up there than I am down here in Houston :) For your issue....do you have access to the UIC Knowledge Base? The first issue I found in the
Electronics Forum | Wed Sep 04 13:58:36 EDT 2019 | smrsteve
Hello Bobpan, Thanks for the response. 1. Function 30 gives me a consistent 182-185, even after nozzle changes. I can vary this by changing mod code 15 and I have been advised to aim for 90-110, but it doesn't seem to make any difference so I've go
| 1 |
