Electronics Forum | Sun May 23 03:04:49 EDT 2021 | acouto
Good morning, at this time i find myself repairing a fuji H24G head, however in all manuals there is no manual on Solving problems of heads, I wonder if anyone can help me or only the brand has this type of documentation. Sorry for my bad English. G
Electronics Forum | Thu Jul 30 14:52:26 EDT 2020 | acouto
thanks, i will do what you advised and check the results
Electronics Forum | Sat Jul 11 04:42:41 EDT 2020 | acouto
During H24G head calibration, the following error appears: "814A000 Hybrid calibration measurement results exceeds range error" Unfortunately the head has already been sent to the mark however the error continues. Can someone give me some tips on how
Electronics Forum | Fri May 28 03:31:56 EDT 2021 | acouto
Thanks for helping, during the opening of the head housing, I realized that a connector responsible for the vision was slightly poorly connected and that could be the cause of the IPS problem. Is there any way to test the head on fuji head cleaning e
Electronics Forum | Thu Jul 30 12:55:16 EDT 2020 | fujipro
If there is no visible fault on the affected Shaft, perform maintenance on the Head. Replace Filter and exchange the Mechanicial Valves or replace the O-Rings on it.
Electronics Forum | Sat May 15 03:47:55 EDT 2021 | acouto
Thanks for the help, I identified the shaft from the calibration and changed the spool, performed a new calibration and did not give the error again. Thank you very much fuji.pro.
Electronics Forum | Tue May 25 05:04:10 EDT 2021 | fujipro
Error codes would be helpful. In most IPS error cases, the Documentation will not help you. For remeasuring the IPS are special Tools needed. You need to send the head to your Fuji Service.
Electronics Forum | Sun Aug 07 13:48:21 EDT 2022 | omar08
Hi guys, I have NXT3 Fuji machine with Head H24. I need to do IPS adjustment brightness , so please explain to me what is IPS ,What is the value GR,GL,GT, how to do IPS adjustement1 and adjustement2. Thank you for all.
Electronics Forum | Mon Jan 18 02:49:03 EST 2016 | nirmex
1-Machine speed. 2-New Head H24 and DYNA Head. 3-New Feeder type W08f 4-New Part Camera. 5-New Y-Axis Flat cable design. 6-New GUI with Touch Screen. 7-Panel Height detection. 8-Feeder raising detection. 9-NPI tools support. 10-Overall machi
Electronics Forum | Thu Mar 07 03:32:32 EST 2013 | benreben
Hi, Can you move the X2 axis manually? if you move head manually(twice) can you see the pulse incremented in the servo menu in IP? with servo just have some parts can defects: -servo it self -servo board -encoder on head
.png)
