Electronics Forum | Sun Aug 30 15:32:33 EDT 2009 | jimmyboz
most fuji error codes are 8 digits, A21E is 2100A21E, it is a report from the MCS that transmission has failed (we knew that) Hit control E from the main screen of the MCS, there should be another error reported from the cp6, ie. 1101000 is x data ou
Electronics Forum | Sun Aug 18 21:06:45 EDT 2019 | dman97
Based on the fuji error codes, It says that the ARCNET cable is disconnected. Make sure that all cables from this module are connected to the QP.
Electronics Forum | Fri Apr 23 02:15:36 EDT 2010 | smellew
Hi Rodrigo, Have you fixed your CP65? do you need some help? llew
Electronics Forum | Fri Apr 16 17:44:40 EDT 2010 | rodrigo
We're still trying to fix a C-axis overflow error in our CP-65. I was swapping servo boards and one of them started to blinks a 2 on the LED single digit display and the machine didn't boot up. I replaced the servo board with a spare we bought on eba
Electronics Forum | Sat Nov 07 18:38:32 EST 2020 | enzik
Hello to all, The Fuji GSP III screen printer was working well yesterday. This morning, the machine turned on and the display screen was showing nothing. I went to the back of the machine and reset one of the VM1152A. The display screen is now showi
Electronics Forum | Thu Sep 15 15:17:21 EDT 2005 | GAK
What kind of error code do you get? Check your sensers my be bad.
Electronics Forum | Mon Mar 09 15:40:32 EDT 2009 | smellew
Rodrigo, Is your machine IP2 or IP2E? if you still have the problem contact me direct, and i will take you through the Schematics. Llew Llew@SurfaceMountEngineering.com
Electronics Forum | Wed Sep 17 05:18:55 EDT 2008 | ralphspm
Our Fuji IP2 has a problem reading fiducial marks.It finds the mark(is shown on console display) but after time gives out the error statement "image display time over".It gives out an error status code of "FFFC" on the console display.Cannot find any
Electronics Forum | Fri Oct 15 16:52:52 EDT 2010 | wingding
Fuji IP2: I am having problems with an MTU Cycle Alarm error. There is no such error listed in the IP2 manual or the MTU manual. It sometimes comes up while placing parts on a board or sometimes right after Zero Set. Does anyone know what generates t
Electronics Forum | Fri May 06 15:15:19 EDT 2005 | lyrtech
Hi, I have an INTERMITENT error on my FUJI IP-2 that cause to me many headaches. The error is " SERVO NOT GOOD". In the books, it means that it is relative to servo amplifier. But I can't assume that is the problem because sometimes the machine wor