Electronics Forum | Tue May 26 11:56:30 EDT 2009 | mmjm_1099
I also use Flexa but we use QP3 and our vision number is 20. I would feel they are comparable libriares.
Electronics Forum | Fri Oct 17 20:26:21 EDT 2008 | diesel_1t
If is IP-1, is using SMD2 vision instead of SMD3 (CPIV-IP3, CP6,7, etc) if so, you must use Vision Number instead of Vision type... if you're using fuji flexa just press F1 on vision number and you will se most common vision numbers depending on shap
Electronics Forum | Mon May 25 20:21:47 EDT 2009 | dcell_1t
Hi there: I'm having trouble to assign an adequate vision Type to dpak components in Fuji Flexa (placed by an IP3, SMD3 vision system). Currently we're using 254 but accuracy is reduced and also can be placed backwards (yes, I know... supplier packag
Electronics Forum | Mon Jun 01 05:23:40 EDT 2009 | kircchoffs
hi manuel, you can try vision 180 frontlight. treat DPAK as two leaded part. assign the the upper and lower leads at 1 and 3.
Electronics Forum | Tue Dec 06 19:44:10 EST 2011 | comando
Hello every one! I need help with a misaligned theta at plcc44, the machine is a IP3 smd3, firmware 2.99, vision card 4400 and both camera type YD2048N on label but in Proper data is set 2 (I don't know if this is right) we use Fuji flexa, Back Lig
Electronics Forum | Fri Jan 05 18:39:49 EST 2024 | madisreivik
Also, sometimes placing heads "skip" some rotation - component is little skewed on board but vision shows "correct" numbers. Probably some mechanical error ?
Electronics Forum | Wed May 27 18:19:58 EDT 2009 | dcell_1t
yesterday I tried with vision type 20, just defined the two pair of leads and error 1CA14003 came up, on flexa error help says the following: Cause: The Vision_type in part data is expressed using hexadecimal notation (??). If ?? equals 0A, 0B, 0C,
Electronics Forum | Tue Oct 11 07:54:26 EDT 2005 | Mark
254 (odd parts) ........ go into the Flexa program and go over the vision number and click on it and than hit F1 for a list of numbers.
Electronics Forum | Fri Nov 01 17:32:34 EDT 2013 | dhruv_trylene
I am sorry for not being clear enough... We have a FUJI CP642 and a IP3 machine. At present, we have to create part data for each and every part used in a job, which consumes a lot of time. I was just wondering if there was a way to minimize this?
Electronics Forum | Wed Apr 22 19:21:42 EDT 1998 | Phillip Hunter
Check with Fuji America Corp. 847-913-0162 ask for service department and/or your local sales rep. I have a quote for a 72mm feeder from Fuji for an IP3 ($ 7,000). Oh yeah, These are customs from Fuji and have no Part Number. (What are you placing
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
