Electronics Forum | Thu Jan 11 19:18:24 EST 2024 | madisreivik
Hello ! FUJI IP3 left head sometimes places component with rotation error. Vision processing SHOWS that component needs rotation Mechanical side is checked, looks fine. Also, changed servo, no effect. It happens randomly, maybe 1 part from 30. It
Electronics Forum | Thu Apr 28 08:04:45 EDT 2005 | stepheniii
I like Mydata, Fuji, and Panasonic equipment. However if you have one, I"m not a fan of mixing. I have worked with the IP3 with MTU. I found it a good solid machine. The only thing at that time was the programing. I believe they have changed thi
Electronics Forum | Fri May 27 08:55:45 EDT 2005 | cyber_wolf
Quick note on Hover Davis, I am not impressed with their Fuji IP feeders at all. They short out and blow IC's up in the MFU's They sell their own feeder set up stand to tell whether or not you have a shorted feeder. What the hell is up with that ?
Electronics Forum | Fri Apr 21 20:00:29 EDT 2000 | Larry Johnson
I have been programming FUJI equipment for about 7 years now, and I am yet to fully understand this. PLCC's on an IP3. Front light, back light? Any CCD Level offsets? I just can't seem to get a good PD that will pass vision consistently. Can anyon
Electronics Forum | Thu Apr 28 11:13:33 EDT 2005 | cyber_wolf
We currently have Fuji's(IP3's included) and Mydata's in our SMT area , so training is not an issue. The reason I was thinking of an IP3 is because they seem to be available for 50K or so. We cannot afford to loose any mag positions on our Mydata's t
Electronics Forum | Tue Mar 17 07:35:37 EDT 2009 | nagesh
We have the IC placer Fuji-IP3 machine.Can this machine be able to place MicroBGA / BGA with good vision system.My card has almost 8 BGA with 4 MicroBGA?Still now i had placed 1 or 2 BGA(Placement by body centering).In this machine the Y- table keeps
Electronics Forum | Tue Dec 06 19:44:10 EST 2011 | comando
Hello every one! I need help with a misaligned theta at plcc44, the machine is a IP3 smd3, firmware 2.99, vision card 4400 and both camera type YD2048N on label but in Proper data is set 2 (I don't know if this is right) we use Fuji flexa, Back Lig
Electronics Forum | Tue Jan 03 13:37:19 EST 2012 | comando
Ok, I'm technical at Napco Security System production factory Dom. Rep. there are 13 line with CP43, IP2, IP3, GL5 etc. Camera #2 don't work at one IP3 and We can't pay Fuji specialist but we have to calibrate it, I chane the camera but i don't know
Electronics Forum | Fri Aug 05 08:15:39 EDT 2016 | jdengler
The IP3 specs are: PCB Dimensions Max: 508 mm x 457 mm - Min: 80mm x 50mm Thickness: 0.8 to 4.0mm Component Capacity Tape: 74 - 8/12mm Device Locations Tray: 40 Locations Placing Rate: 0.55 sec/component for small chips 1.25 sec/component for ICs
Electronics Forum | Wed Oct 25 11:25:12 EDT 2017 | paddyronan
Hi all, I have a recent issue with an IP3 machine. The machine cycles through normal power up routine. Then the video monitor and VME card shit themselves down and after a couple of minutes the CPU board powers down. However this is intermittent. Wh