Electronics Forum | Sat Aug 19 07:50:26 EDT 2006 | johnw
Hi Jorge, tell me what is happening and I will help you out,I am a Fuji Engineer.
Electronics Forum | Wed Aug 23 08:12:31 EDT 2006 | jdengler
Do you have another copy of firmware? This is a long shot but you seem to be running out of options. If you can try a different firmware for the machine and for the vision. Jerry
Electronics Forum | Tue Dec 19 03:40:38 EST 2006 | aj
I had this happening before. It is a simple adjustment on the Z-axis belt. Basically the dog is not making the sensor correctly and driving on further. I think you have a lot more issues if the shaft was damaged. aj...
Electronics Forum | Wed Dec 20 17:03:50 EST 2006 | aj
By the way , changing the ball screw will also sort your problem out because you will have to carry out the Z-axis setup ( belt tension etc ) as part of the change. so it is worth a shot to carry out the setup and see how it goes! you will have nothi
Electronics Forum | Thu Feb 14 22:19:05 EST 2008 | ashley
hello Keith, the problem may be related to a faulty / dirty linear scale. kindly check on the yellow strip along the X axis. clean & clear the glass linear scale of debris & grease. for Fuji support & spare parts, please write to :- apexservice@
Electronics Forum | Thu Oct 02 10:43:37 EDT 2008 | msangabriel
I am looking for companies that fabricates special or custom SMT feeders for an Fuji IP3 machine. It is to feed a SMT terminal. Do you know of any company that you can recommend?
Electronics Forum | Tue May 26 11:56:30 EDT 2009 | mmjm_1099
I also use Flexa but we use QP3 and our vision number is 20. I would feel they are comparable libriares.
Electronics Forum | Mon Jun 01 05:23:40 EDT 2009 | kircchoffs
hi manuel, you can try vision 180 frontlight. treat DPAK as two leaded part. assign the the upper and lower leads at 1 and 3.
Electronics Forum | Wed Feb 24 11:36:06 EST 2010 | kruzon
Is there a simple way to create vision data for bga's. Our machine is a Fuji IP3. I have a bga with balls all over the place. Thanks -
Electronics Forum | Thu Jun 10 07:44:41 EDT 2010 | jdengler
Did the machine work when you first installed it? Have you done a reset start yet? Make sure you have air applied when you power up. The IP's don't like to power up without the air.