Electronics Forum | Wed Jun 09 10:41:28 EDT 2010 | chrislyttle
We've been having some problems with out Fuji IP2E machine that we've recently bought from a company that is no longer operating here. Since installing it we've encountered a few problems with it starting up. To give you a quick breakdown of its be
Electronics Forum | Thu Jun 10 07:44:41 EDT 2010 | jdengler
Did the machine work when you first installed it? Have you done a reset start yet? Make sure you have air applied when you power up. The IP's don't like to power up without the air.
Electronics Forum | Tue Feb 24 15:32:10 EST 2015 | swiese242
Hi there. I have an IP3 machine that refuses to > power up the MFU cart on side 1. I have already > replaced the I/O card but still no dice. Is > there a relay or fuse that I need to check to get > this to power up? The machine will not operate
Electronics Forum | Thu Feb 19 12:22:52 EST 2015 | dman97
Hi there. I have an IP3 machine that refuses to power up the MFU cart on side 1. I have already replaced the I/O card but still no dice. Is there a relay or fuse that I need to check to get this to power up? The machine will not operate the camera
Electronics Forum | Tue Nov 03 12:21:53 EST 1998 | phillip hunter
| Thanks for your reply. | I am interested in knowing about maintenance schedules and levels. I'm wondering how to know if I must replace a part. What part? What type of lubrication (for Fuji). Etc. | My company is small in terms of number of lines
Electronics Forum | Fri Nov 20 23:00:07 EST 1998 | David Lombard
| | Thanks for your reply. | | I am interested in knowing about maintenance schedules and levels. I'm wondering how to know if I must replace a part. What part? What type of lubrication (for Fuji). Etc. | | My company is small in terms of number of
Electronics Forum | Thu Jun 10 13:41:59 EDT 2010 | cyber_wolf
The transformer was probably wired wrong and you done blowed ol bessie up.
Electronics Forum | Wed Apr 22 12:50:39 EDT 2020 | rodrigo
Hi all, One of our Fuji CP-642 machines has a weird problem. It does not happen every time but often enough that it is a problem. I power up and press start to zero it. The problem is the zero...ing does not finish. It moves the xy-table, D1/D2 table
Electronics Forum | Mon Jul 17 20:50:42 EDT 2017 | davef
For service related problem, contact Dave Byker at 847-913-0162
Electronics Forum | Tue Mar 19 16:55:54 EST 2002 | Steve E ( Fujiamerica )
This problem happens when a dark part is placed where the main conveyer stop sensor is located.The machine does a board check ( back to loading pos ) . If a part is under the sensor it absorbs the beam and the machine thinks there�s no board. The ta
.gif)
winsouce.jpg)
