Electronics Forum | Wed Dec 20 17:00:29 EST 2006 | aj
Have you contactd your Fuji Engineer for advise. I would really look at the z-axis belt setup before investing that sort of money. We had the exact problem here and that is all it was. aj...
Electronics Forum | Mon Mar 04 13:48:53 EST 2013 | orlando216
Greetings to all, I have the following problem with an IP-3 from Fuji, At display is says: Cannot Move: X1 Axis Feeding aborted Servo Alarm X2 AXIS Servo Ove
Electronics Forum | Fri Mar 08 22:07:31 EST 2002 | winter
I think the reason of the problem is the sensitivity of some sensor.maybe it's the main conveyor arrival sensor .I think you can do a test , make the sensor always on, and tese.
Electronics Forum | Wed Oct 17 08:09:09 EDT 2012 | fujiphil
This problem is caused by poor pick-up. Check the pick-up from MTU to shuttle, then shuttle to placing head 1. If the pick-up is not centered, adjust proper data.
Electronics Forum | Wed May 17 03:00:45 EDT 2000 | Avichai Ramot
I have shifts in the placement of qfp240 components. I have this problem with al my IC machines: Fuji-Ip2,Ip3 ,siemens F-4.
Electronics Forum | Fri Sep 16 08:36:45 EDT 2005 | ajay
check some relay might be bad on MTU. we faced similar problem in IP3.
Electronics Forum | Wed Aug 23 08:12:31 EDT 2006 | jdengler
Do you have another copy of firmware? This is a long shot but you seem to be running out of options. If you can try a different firmware for the machine and for the vision. Jerry
Electronics Forum | Wed Dec 20 17:03:50 EST 2006 | aj
By the way , changing the ball screw will also sort your problem out because you will have to carry out the Z-axis setup ( belt tension etc ) as part of the change. so it is worth a shot to carry out the setup and see how it goes! you will have nothi
Electronics Forum | Thu Feb 14 22:19:05 EST 2008 | ashley
hello Keith, the problem may be related to a faulty / dirty linear scale. kindly check on the yellow strip along the X axis. clean & clear the glass linear scale of debris & grease. for Fuji support & spare parts, please write to :- apexservice@
Electronics Forum | Thu Jun 10 07:44:41 EDT 2010 | jdengler
Did the machine work when you first installed it? Have you done a reset start yet? Make sure you have air applied when you power up. The IP's don't like to power up without the air.