Electronics Forum | Thu Apr 12 15:21:12 EDT 2012 | jdengler
Have you tried to do a reset start? When Fuji's act weird the first place to start is a reset start, then re-load the Proper Status and Program. Jerry
Electronics Forum | Thu Apr 12 17:49:35 EDT 2012 | rodrigo
I've done the Fuji flush. It does the same thing. We can not load proper again because it does not communicate with either the F4G or MCS/30. I was able to boot into mechanical mode at one point but now I can not do that either. This thing is drivi
Electronics Forum | Tue Jul 05 16:58:00 EDT 2022 | jdengler
When these old Fuji's do weird things I usually try a reset start. Many times that fixes the issue. Make sure you have a valid proper file before you try it. Jerry
Electronics Forum | Thu Jun 10 07:44:41 EDT 2010 | jdengler
Did the machine work when you first installed it? Have you done a reset start yet? Make sure you have air applied when you power up. The IP's don't like to power up without the air.
Electronics Forum | Thu Mar 07 09:03:03 EST 2002 | cabjerk
After the IP3 is stopped by any means ie. Estop, cycle stop, or machine runs out of parts, upon restart the table will go to load position, unclamp, reclamp, read the fids and then proceed as normal. The problem is that if we already have fine pitch
Electronics Forum | Fri May 01 00:27:12 EDT 2009 | rodrigo
Hi all, We had a servo amp replaced (SA-6) and the machine worked with no problem for the first panel (this panel of 10 only needs a TQFP100 from the MTU). Then I got the "Servo NG" error again. One of the servo paks showed a "7" on the LED. The err
1 |