Electronics Forum | Tue Mar 17 07:35:37 EDT 2009 | nagesh
We have the IC placer Fuji-IP3 machine.Can this machine be able to place MicroBGA / BGA with good vision system.My card has almost 8 BGA with 4 MicroBGA?Still now i had placed 1 or 2 BGA(Placement by body centering).In this machine the Y- table keeps
Electronics Forum | Wed Oct 17 14:26:30 EDT 2012 | dman97
With that said, do you happen to have the calibration procedure for the MTU? I already have the X0 Y0 jig. Just need to know where exactly I am supposed to calibrate with regards to the actual trays.
Electronics Forum | Tue Mar 19 16:55:54 EST 2002 | Steve E ( Fujiamerica )
This problem happens when a dark part is placed where the main conveyer stop sensor is located.The machine does a board check ( back to loading pos ) . If a part is under the sensor it absorbs the beam and the machine thinks there�s no board. The ta
Electronics Forum | Wed Mar 20 13:49:15 EST 2002 | cabjerk
Hi All; The following is from our Support people who worked with Fuji on the problem; Last week Luke Mittur and John Gudel were in from Fuji to address the IP3 issue outlined below. The problem ended up being that the table "up" and table "dow
Electronics Forum | Mon May 04 22:42:46 EDT 1998 | Phillipf Hunter
Okay, Fuji MTU4 experts...I need a precise way to determin the X-origin and Y-origin of the tray plates. The center of the S-nozzle referenced to the plate corner is very difficult to EXACTLY measure. I need accuracy to pick small QFP28's - otherwi
Electronics Forum | Mon Mar 19 16:50:23 EDT 2018 | magergar
Acording to the manual the resolution for the narrow camera is 22.5 um/pix but is setup at 45um/pix (wide resolution), I tried to change it in the proper 113.Camera1_Pixel_X and 114.Camera1_Pixel_Y but I'm not allow to change this parameter it is bl
Electronics Forum | Fri Apr 15 08:23:14 EDT 2005 | cyber_wolf
We are seeing more and more jobs come in with matrix tray parts for our mydata machines. The problem is that the largest Y wagon will only hold 3 or less trays. We have some jobs that have 10+ trays. Currently our operators cut the trays down to sma
Electronics Forum | Wed Sep 16 16:54:18 EDT 1998 | Doug Nebel
We are currently using a Mydata TP18 UFP to do placements on boards 520 mm x 460 mm. The table is expandable and Mydata was boasting of a custom table that was 820 mm x 540 mm. One drawback of our machine is that it is a stand alone machine, so han
Electronics Forum | Wed Apr 24 03:24:53 EDT 2002 | Gang shen
today I succeed placing the BGA at the other table(table2), the part data is only changed with "pitch_limit"=50%,lead_check_ area=50%,lead_brightness=0. but when I process vision at the tale1(which equipped the MTU),still failed,the error message is
Electronics Forum | Tue Feb 24 15:32:10 EST 2015 | swiese242
Hi there. I have an IP3 machine that refuses to > power up the MFU cart on side 1. I have already > replaced the I/O card but still no dice. Is > there a relay or fuse that I need to check to get > this to power up? The machine will not operate
winsouce.jpg)
.gif)
