Electronics Forum | Fri Sep 01 19:54:31 EDT 2017 | tmennink
What was the outcome OrHorti after baking some? In the end we went with a different machine (Fuji NXT) which was able to get the leds out of the reel. After switching we still face a loss of about 0.5% but it is acceptable for now.
Electronics Forum | Wed Mar 16 20:44:54 EDT 2016 | sonavc
Thanks every one. I fixed the problem. It was the VM1540A I/O board. Now run back to normal
Electronics Forum | Thu Feb 04 18:16:53 EST 2016 | sonavc
Hi Thanks, help me to fix this old CP3. It ran great till now, I have problem the CPU board's Led HALF on . When the machine boot fine . it is good about 3 minutes then the CPU board 's Led HALF in always on. Turn off then back on sometime it is sho
Electronics Forum | Thu Mar 17 12:49:12 EDT 2016 | mnorthey
Thanks every one. I fixed the problem. It was the VM1540A I/O board. Now run back to normal Glad to hear you got it going, I have a Fuji repair manual if you would like to have it. I also have some old circuit cards I don't need anymore. Let me
Electronics Forum | Tue Jan 01 22:50:53 EST 2008 | fastek
To get beyond the 36,000 cph threshhold the turret manufacturers had to focus on ways to get the boards in and out of the machine faster. This also included loading more boards inside the worknest. The end result in Fuji's case (CP-643), was a table
Electronics Forum | Tue Nov 20 12:06:21 EST 2018 | reckless
Great explanation! In my operation I have all tiny chips, 1 SOT223 being largest part but I do have 1 3mm tall inductor which won't work with this machine. Other than 1 part I could run my entire production on it. Also looks perfect for LED produc
Electronics Forum | Tue Mar 10 14:11:42 EDT 2009 | rodrigo
Ok I checked and here are the results... Z1 11CS3x Green LED on Q1 11cs4x Green LED on Z2 12cs3x Green LED off (This is the relay I mentioned in my original post). Q2 12cs4x Green LED on M1CR4x Green LED off The servopack SA-6 is the one with the
Electronics Forum | Wed Oct 02 00:35:33 EDT 2013 | sonavc
thanks I tested the conveyor A or B , when it is on the motor turn and the green LED at the out put card is also light on. But when i turn on the X y table motor , the green LED is on , but the motor is not run. I will try to replace the I/O
Electronics Forum | Wed Aug 02 05:27:00 EDT 2017 | tmennink
We did this test, we opened the tape and turned it upside down, indeed some leds were staying inside the tape. We will try placing them next week with a fuji NXT line. We also contacted the manufacturer, apparently heat perhaps during transport coul
Electronics Forum | Fri Jul 19 10:45:55 EDT 2013 | kdc45
Have a Fuji IP-2 and the MTU has a servo alarm. There are three servo amp cards and the middle card is showing a 1 on the LED display. Does anyone know what this indicates? Also, can you tell me which axis this card is for? We do not have an advanced
