Electronics Forum | Sat Sep 28 15:58:38 EDT 2013 | sonavc
Hi. 'm new to this Fuji CP3, I bought this machine in working condition ( I saw it ran, but I forgot to check the board in and out ).... Moved to my location, Problem: When the board is trying to load to the X-Y table, it passed the conveyor B but
Electronics Forum | Mon Jun 10 14:10:08 EDT 2019 | griinder
I am able to create a single board program using gerber and centroid, and teaching footprints. I can then assign 2 global fids(a third never seems to display in Ceditor), and export my pad file. I then open it in ceditor and export the job file. Load
Electronics Forum | Thu Jan 20 07:58:46 EST 2011 | jdengler
Hi Bert, Take all feeders off of the machine. Do a reset start (hold reset switch in while powering up the machine). This will flush the memory so you will need to load PROPER, STATUS, PROGRAM. If it still does it you may have a short in a feede
Electronics Forum | Wed Oct 15 15:08:05 EDT 2008 | mbrunton
I have a Fuji IP1 using the MCS control system. Everything works fine, but it seems to have tons of problems placing PLCC4 parts (Osram Power TopLED). Some reels I load up it will give a vision processing error for about 1 out of 10 parts. Other r
Electronics Forum | Thu Apr 12 17:49:35 EDT 2012 | rodrigo
I've done the Fuji flush. It does the same thing. We can not load proper again because it does not communicate with either the F4G or MCS/30. I was able to boot into mechanical mode at one point but now I can not do that either. This thing is drivi
Electronics Forum | Tue Feb 17 15:28:43 EST 1998 | Steve Schwarz
| Do anyone know of any feeder maintenance programs, | software, etc.? We carry over 1000 Fuji feeders and | would like know what the standard is to maintain these. | Any suggestions would be helpful. | Thanks, | Reggie Aquino *** Warning Blatant V
| 1 |
