Electronics Forum | Tue Jun 20 19:12:41 EDT 2023 | madisreivik
Hello all ! FUJI IP3 starts up, makes zero setting OK But if I start AUTO mode, it gives error -------------------------------------------------------------------------------- Code 11082010 UsedBy MTU3,MTU4,MTU5 Display Usable Proper Data has
Electronics Forum | Tue Jun 20 21:42:19 EDT 2023 | jdengler
The MTU has it's own proper data file. You need to send that to the MTU.
Electronics Forum | Wed Jun 21 06:10:36 EDT 2023 | madisreivik
Thanks ! I totally forgot that MTU had its own prop file, uploaded it from Flexa and now works fine.
Electronics Forum | Sat Jun 24 13:08:09 EDT 2023 | madisreivik
All is OK now. The machine was offline couple months and probably some memory battery is dead. All problems were solved after uploading prop data to IP and MTU.
Electronics Forum | Fri Jul 17 19:43:20 EDT 2009 | fujiphil
Have you eliminated the hardware N.G.? Check the connection for the rear door. If the connection are ok, try to bypass the key. short the two wires for the rear door. If the rear door problem is corrected, check the rear door switch physically. Reg
Electronics Forum | Thu Sep 16 18:25:22 EDT 2010 | slwolbert
Thanks for the response Travis. I'd think the table would inch or move if it were stuck inching keys. The table would eventually trigger one of the overtravel sensors on this ancient machine. Much Appreciated, Steve
Electronics Forum | Fri Dec 21 09:40:40 EST 2018 | kdexter0928
I am at wits end with this machine. The MTU on my IP2 will not zero set. It gives me a few different errors depending on its mood. I receive MTU T- OT, MTU X- OT, or MTU Y- OT. when the machine attempts to zero set it travels until it OTs. I have tri
Electronics Forum | Fri Oct 15 16:52:52 EDT 2010 | wingding
Fuji IP2: I am having problems with an MTU Cycle Alarm error. There is no such error listed in the IP2 manual or the MTU manual. It sometimes comes up while placing parts on a board or sometimes right after Zero Set. Does anyone know what generates t
Electronics Forum | Wed Jan 02 12:03:13 EST 2019 | jdengler
They go through TN-3 to get to the TSA-200A D/A module. This is all in the MTU. It's been a long time since I worked on an IP-2 but see if you can get to the I/O screen for the MTU. Have someone flag the in range sensor and see if the input status on
Electronics Forum | Fri Jun 23 21:10:29 EDT 2023 | meher
To resolve this issue, you need to ensure that the proper data is stored and transmitted to the MTU. Double-check the communication settings between the machine and the MTU during the startup process. Make sure that all the necessary data is being se
