Electronics Forum | Fri Oct 03 07:49:19 EDT 2008 | grantp
Hi, I just saw the new NXT machines at globaltronics in Singapore, and mostly they are faster. However what was interesting is Fuji shows a prototype of the new XPF machine, but it was called XPF-W which handles really large PCB's and uses the sam
Electronics Forum | Thu Feb 02 18:17:47 EST 2006 | grantp
Hi, I think you can run the wide modules if you need to run large boards. However we went for a bunch of XP machines instead of NXT, because we can use IP and CP feeders, plus we get 100 feeder slots per XP-143, where each module of NXT has less. Bu
Electronics Forum | Thu Feb 02 11:12:58 EST 2006 | smtuser1234
Watch out for the large board trick. You have to turn the board 90 degrees to run it.
Electronics Forum | Thu Oct 04 00:01:59 EDT 2018 | gaintstar
Flason SMT FUJI Pick and Place Machine: http://www.flason-smt.com/product/FUJI-Chip-Mounter-SMT-spare-parts-A10395-Fiber-Amplifier.html http://www.flason-smt.com/product/FUJI-Chip-Mounter-SMT-spare-parts-Amplifier-A1038t.html http://www.flason-smt.co
Electronics Forum | Tue Apr 14 15:57:22 EDT 2009 | mikesewell
We have both NXT and AIM. Be aware of the width limitation (250mm?)on the M3 module, if you go over it then you have to pair with an adjacent module to build the board.
Electronics Forum | Mon Oct 17 15:11:34 EDT 2005 | ricardof
FUJI NXT single lane can run up to 23"x21". SIEMENS HF can run up to 23"x21" as well. Now, what kind of production are you doing? I think that 20" boards are for mid to low volume, my thinking is that SIEMENS can do that if you can afford the cost, o
Electronics Forum | Mon Oct 17 15:22:38 EDT 2005 | Mike W
I would only suggest this machine IF I were a Fuji salesman. The NXT will ALWAYS derate by over 40% for boards longer than 10"
Electronics Forum | Wed Oct 20 11:39:01 EDT 2010 | mikesewell
On our Fuji NXT and AIM machines I never program local fids...we place down to 16 mil fine pitch and BGA, uBGA, multirow QFNs with no placement issues. Most boards are panelized in an array and we have corner fids added to the rails. Regards, Mi
Electronics Forum | Thu May 06 15:46:08 EDT 2004 | Automation Engineer
I am looking at putting in a 100,000+ cph assembly line capable of processing 8" X 8" boards. Mix is passsives down to 0402, 15 mil pitch flip chips. I would like to hear what comments you have on the new Assebleon AX, Fuji NXT, Siemens HS-60, Univ
Electronics Forum | Tue Oct 12 13:40:14 EDT 2004 | Jimmy
We recently went through an evaluation period of an NXT modular setup. We ended up purchasing the 2XM6 setup mainly due to the board length limitation of less than 10 inches for the M3 modules without splitting feeders. The machine has been extremel
winsouce.jpg)
