Electronics Forum | Sun Oct 02 10:40:10 EDT 2022 | omar08
Hi, I have this problem in NXT3 fuji machine . 80001919 vacuum break completion error. 88D40000 Placement (part rejection ) error
Electronics Forum | Tue Mar 16 17:34:27 EDT 2021 | dan_ems
Hello, can you help please with a question regarding Fuji NXT programming? During the placement of the components on the fuji interface the image of the components during alignement can be seen on the Fuji operator interface. My question is can be al
Electronics Forum | Sun Oct 09 13:16:13 EDT 2022 | acouto
yes, they have already been tested with different heads and the error persists.
Electronics Forum | Wed Oct 20 11:39:01 EDT 2010 | mikesewell
On our Fuji NXT and AIM machines I never program local fids...we place down to 16 mil fine pitch and BGA, uBGA, multirow QFNs with no placement issues. Most boards are panelized in an array and we have corner fids added to the rails. Regards, Mi
Electronics Forum | Tue Dec 07 14:13:59 EST 1999 | vahid vatannia
Is it true that "square" fiducials cause less error than round fiducials? Also, how does Panasonic machines stack up against Fuji, Siemens, or Philips placement machines? Thank you.
Electronics Forum | Thu Feb 02 20:48:07 EST 2006 | ____
I would like to start a new post regarding fuji > NXT machine. What do you think about the machine > as far as the servicing of the machine goes. I am > so used to the older machines such as : CP,IP, > and QP. Those machines at least give you som
Electronics Forum | Fri Oct 07 04:26:13 EDT 2022 | acouto
We are having an issue after performing a head cleaning. Error 0x0000D005 - "An error that can be cleared (alarm) has occurred at the axis" We are trying to solve this problem but every time we insert a head into the cleaning machine, it gives us the
Electronics Forum | Wed Sep 17 05:18:55 EDT 2008 | ralphspm
Our Fuji IP2 has a problem reading fiducial marks.It finds the mark(is shown on console display) but after time gives out the error statement "image display time over".It gives out an error status code of "FFFC" on the console display.Cannot find any
Electronics Forum | Sat Aug 22 10:25:11 EDT 1998 | Ben Salisbury
| We are using PCBs of CEM3 Material with bare copper fiducials. The whole | board is of bare copper with a lacquer coating (Coats brother S2974). | The fiducials are of 1 mm diameter bare copper. we use Panasert MV2F as | well as Fuji CP4-3. In bo
Electronics Forum | Tue Dec 07 14:23:34 EST 1999 | JAX
Vahid, What type of error are you talking about? If you mean accuracy I would stick to round fiducials. As far as machines, the only question is about active component placement. For passive components Fuji(CP-series) is the way to go. O
