Electronics Forum | Wed Oct 15 15:08:05 EDT 2008 | mbrunton
I have a Fuji IP1 using the MCS control system. Everything works fine, but it seems to have tons of problems placing PLCC4 parts (Osram Power TopLED). Some reels I load up it will give a vision processing error for about 1 out of 10 parts. Other r
Electronics Forum | Mon May 14 16:39:38 EDT 2001 | T.F.
Siemens makes feeder hold down brackets for the F5 that does prevent the operator from leaving the feeder in a position that can cause a crash. The brackets attach to the feeder table so you need one bracket per table. The part part number for the b
Electronics Forum | Fri Sep 16 12:52:13 EDT 2005 | timekey
Steve- Depending on which Fuji model you have, Fuji PAM either needs to be purchased from Fuji or if you have a CP-7, CP-8 or NXT, Fuji PAM is already installed in the machine from the factory. The kit...if you are required to purchase it from Fuji i
Electronics Forum | Mon Sep 06 14:01:08 EDT 1999 | KEVIN SIMPSON
| | We are using some Fuji machines and have trouble picking parts up from damaged or mis-adjusted feeders. When I was working with Panasonic machines I was able to buy a feeder alignment jig from them to align the pick spot in the feeder, but Fuji d
Electronics Forum | Mon Sep 06 08:05:51 EDT 1999 | stefano bolleri
| We are using some Fuji machines and have trouble picking parts up from damaged or mis-adjusted feeders. When I was working with Panasonic machines I was able to buy a feeder alignment jig from them to align the pick spot in the feeder, but Fuji doe
Electronics Forum | Tue Sep 07 14:24:20 EDT 1999 | johng
| | We are using some Fuji machines and have trouble picking parts up from damaged or mis-adjusted feeders. When I was working with Panasonic machines I was able to buy a feeder alignment jig from them to align the pick spot in the feeder, but Fuji d
Electronics Forum | Wed Sep 08 16:56:06 EDT 1999 | Md Cox
| | | We are using some Fuji machines and have trouble picking parts up from damaged or mis-adjusted feeders. When I was working with Panasonic machines I was able to buy a feeder alignment jig from them to align the pick spot in the feeder, but Fuji
Electronics Forum | Fri Oct 01 00:44:41 EDT 1999 | Hon Choi
If permanent set processing is used, designate the permanent set table name (PST). The Separator uses the PST to restrict the allocation of specified parts to certain feeder positions on the unit (device) table. The PST is mainly used for efficiency
Electronics Forum | Sat Jul 03 19:24:25 EDT 1999 | JohnW
50% reduction in time. One draw back, the availability of feeders... You need 280 feeders max to change over a max capacity of 140 feeder machine (or a variance of a product mix vs. part numbers); then there's 8mm, 12mm, 16mm, sticks feeders that c
Electronics Forum | Sat Jul 03 18:14:03 EDT 1999 | Earl Moon
50% reduction in time. One draw back, the availability of feeders... You need 280 feeders max to change over a max capacity of 140 feeder machine (or a variance of a product mix vs. part numbers); then there's 8mm, 12mm, 16mm, sticks feeders that c
winsouce.jpg)
