Electronics Forum | Thu Oct 30 21:06:20 EDT 2008 | ashley
Hello mickd, For Fuji practice, the primary tooling hole preferably be 5mm from the edge of the PCB (lower right hand corner). This is the reference X0, Y0 co-ordinates in the Fuji program where placing co-ordinates going LEFT will be -ve value & go
Electronics Forum | Mon Jan 08 13:24:52 EST 2001 | Stefan Witte
I have a hard time reading ( and understanding ) the manuals of several different machines, I am exposed to. I wonder if this web site could help me in the task to collect short versions of machine manuals, written by machine operators, for the Fuji'
Electronics Forum | Fri Jun 24 01:01:41 EDT 2005 | FAC
If you are only concerned with the outline and it has 4 corners, VT-10 or 254 will work with backlighting. If the FIP3 machine has a 4400 card installed, frontlighting with high I/O counts could take a while during vision processing. If your machine
Electronics Forum | Fri Aug 16 11:40:43 EDT 2002 | smter5903
What Pana equipment? > > Regards, > > Pete Barton I didn't get any more info from your companies! Is this hard to find stuff?
Electronics Forum | Thu Aug 22 23:26:01 EDT 2002 | mjabure
It's been quite a few ywars since I dealt with Panasonics but you might try Panasonic factory automation. I believe they are in Elgin, Illinois now. You might try their website I believe the URL is http://www.panasonicfa.com
Electronics Forum | Fri Apr 15 15:04:02 EDT 2005 | lyrtech
Hi, Sometimes we have the following error: " TABLE BASE NOT GOOD ". In the manual, it says that we have to check the cylinder and other parts around the table. This is not very specific. Can anyone helps us with some hints? Thank you
Electronics Forum | Wed Jun 29 08:48:39 EDT 2005 | jdengler
The MCS30 maintenance manual has a procedure near the back on exactly what to do for this error. Jerry
Electronics Forum | Tue Jan 24 10:39:45 EST 2006 | O.K.
Hello everybody ! I am looking for manuals or catalogs for different makes of feeders - fuji, siemens, gsm. does anybody know where to find it ? thanks in advance, any replies will be appreciated.
Electronics Forum | Tue Jan 16 07:18:17 EST 2007 | jdengler
I got a manual for the TEAC unit (free from TEAC). Calibrated the unit to their specifications and it works properly now.
Electronics Forum | Fri Nov 04 13:08:32 EDT 2011 | dwoodbury
Hi. We are having problems with what appears to be the firmware for our QP341 machine. It will not allow us to calibrate or change any settings for the pick-up-point on the tray unit. We are following the procedure in the manuals but it is not workin
.gif)
winsouce.jpg)
