Electronics Forum | Wed Jan 11 10:39:28 EST 2017 | davef
From “Nick's Software Blog” [http://nicks-software.com/wordpress/tag/list-of-abbreviations/ ] a very cool list of abbreviations … * SCU, Servo control unit or Sub-controller unit (on Fuji machines). * PMC, Placing module controller (on Q.P. Fuji ma
Electronics Forum | Fri May 31 16:16:42 EDT 2002 | Ozzy
Does Fuji even make the QP-132 anymore? I have not seen it at Apex for the past 2-3 years. This "inflexible" dinosaur was a commercial disaster for Fuji. Philips/Assembleon has sold countless more FCM than Fuji QP-132. The problem with both machines
Electronics Forum | Tue May 22 09:11:35 EDT 2007 | jola
Hi. We have changed our produktion from high volume to medium/low and have to start hunting change-over time. We have a lot of products with two sides and the settings of pins in the DEK 265 and Fuji QP242 machines when running b-side takes to long t
Electronics Forum | Mon Jan 07 12:42:15 EST 2008 | rschnic
We have a Fuji QP341 machine and would like to connect to the GEM port and collect production data. We are unable to connect to the standard port 5000. I assume this is because the controller is connected to it. Does anyone have any experience with
Electronics Forum | Fri May 22 07:59:14 EDT 1998 | Jerry
We are currently comparing the Fuji QP2 machine to the Universal GSM. The primary use will be for QFP's down to .4 mm pitch and for 300+I/O BGAs. My initial input has been that you spend alot of time tweeking PD's on the QP because the vision syste
Electronics Forum | Thu May 28 18:16:40 EDT 1998 | Ian Bates
| We are currently comparing the Fuji QP2 machine to the Universal GSM. The primary use will be for QFP's down to .4 mm pitch and for 300+I/O BGAs. My initial input has been that you spend alot of time tweeking PD's on the QP because the vision sys
Electronics Forum | Mon Apr 15 15:34:07 EDT 2002 | Bob
Hi, I have loads of experience with QP132's. You can change over product quite easily depending on a few things: - � The board sizes should be the same otherwise pallet adjustment can take an hour or so. � If you can fit all the feeders on one set-u
Electronics Forum | Wed Apr 24 11:02:01 EDT 2002 | cnoonan
This may not be the answer you were looking for, but I have worked for serveral leading technology companies and we used vision (type 10)on IP3, and QP3 machine and never had a problem with placement issues.
Electronics Forum | Sat Jul 31 21:52:55 EDT 2004 | mat
Do you know how to control MTU magazine speed for QP341E,is it in the Fujicam part editor?
Electronics Forum | Tue May 03 07:54:40 EDT 2005 | scotceltic
Does anyone have any contact info. for affordable custom tube feeder setup for a FUJI QP3 Machine ?? I have already tried Component Express. Although their application would work it is just too big for us.
winsouce.jpg)