Electronics Forum | Tue Nov 03 12:21:53 EST 1998 | phillip hunter
| Thanks for your reply. | I am interested in knowing about maintenance schedules and levels. I'm wondering how to know if I must replace a part. What part? What type of lubrication (for Fuji). Etc. | My company is small in terms of number of lines
Electronics Forum | Fri Nov 20 23:00:07 EST 1998 | David Lombard
| | Thanks for your reply. | | I am interested in knowing about maintenance schedules and levels. I'm wondering how to know if I must replace a part. What part? What type of lubrication (for Fuji). Etc. | | My company is small in terms of number of
Electronics Forum | Sat Dec 12 12:25:14 EST 1998 | David Lombard
| My Fuji IP3 keeps getting the Check Sensor Error. | What is the problem? | This problem is caused by either of two things. First the vacuum chuck get dirty and needs to be cleaned "PM". If the problem is persistant the vacuum chick has worn down
Electronics Forum | Sat Dec 12 12:26:08 EST 1998 | David Lombard
| My Fuji IP3 keeps getting the Check Sensor Error. | What is the problem? | This problem is caused by either of two things. First the vacuum chuck get dirty and needs to be cleaned "PM". If the problem is persistant the vacuum chick has worn down
Electronics Forum | Mon Jan 10 17:00:56 EST 2005 | Johnw
you may have a servo reach pulse error go into mecha check and check zero dev
Electronics Forum | Mon Jun 19 13:53:18 EDT 2006 | choppy
Does it reach the home sensor ? Is it activated ?
Electronics Forum | Sat Nov 19 18:35:39 EST 2011 | johndoe0222
We have an old Fuji GSP III-4000 we just changed the fiber sensor on the in-bound and outbound of the printer. The problem we are having now is the board would only go midway the table and it would go up. It does not even reach the main stopper and t
Electronics Forum | Sun Jul 09 03:05:14 EDT 2000 | Ben
Hi Hermie, Did you perform a Servo-zero-adjustment and Gain calibration on the amplifier after replaced it ? This is necessary fine turning when replacing the amplifier. You had better ask Fuji service center for the procedure. Hope this help you.
Electronics Forum | Mon Jul 03 23:29:26 EDT 2006 | grantp
Hi, Don't know about your machines, but our XP Fuji machines have a lubrication tube linking the under side of the machine to the top, so you can put a grease gun on it, and push grease into hard to reach places. Does yours have that? If your heari
Electronics Forum | Sat May 29 15:58:37 EDT 2004 | Patrick Tarell ... Automation Engineering Jabil Circuit
Hello Alan! We have used both chipshooters, we also have a Mydata with the hydra head... We switched entirely from Fuji CP7 to the UIC HSP4796 and now HSP4797. The CP7 is a nice machine but we were very unhappy with the support structure within Fu
