Electronics Forum | Wed Oct 10 10:35:43 EDT 2007 | cyber_wolf
We are using the tapered nozzles.
Electronics Forum | Wed Oct 10 11:11:22 EDT 2007 | chrisgriffin
Make sure the lights are clean and bright. Are you running at 100% speed?
Electronics Forum | Thu Oct 11 06:36:57 EDT 2007 | cyber_wolf
Feeder is brand new. (Checked cal. even though it was new) Lighting is good. Machine is in perfect cal. Nozzles are brand spankin new from Fuji. I was able to lower the reject rate considerably by playing with the offset and gain. I am placing caps
Electronics Forum | Wed Oct 10 09:42:02 EDT 2007 | fredc
Hello Sr.Tech, There have been two types of nozzles made by Fuji for 0201's one was a 1mm tapered to .4mm and the other has a straight .4mm tube. Has one superceded the other and if you have used both types, did one work better than the other? Asking
Electronics Forum | Wed Oct 10 08:13:03 EDT 2007 | cyber_wolf
Hi, What is the expected reject rate for capacitors on a CP643 machine. I estimate that we are dumping around 1 in 20 on average. I have played around with lighting levels,vision types etc. Nozzles are in mint condition. Can anyone offer any advice
Electronics Forum | Wed Oct 10 11:20:31 EDT 2007 | jdengler
Do all 0201's reject at the same rate? If even 1 P/N has a lower reject rate this can point towards a feeder problem. I have had a similar problem on a CP-IV-2 with 0402's that was caused by feeders. If all reject at the same rate it can be the PD o
Electronics Forum | Tue Aug 11 15:58:10 EDT 2020 | gilbe12586
Looking for FUJI CDC-4200-2 conveyor manual, belts, and bearings.
Electronics Forum | Thu Jul 22 07:30:21 EDT 2010 | nitronica1
does anyone know where I can get replacement conveyor/drive belts for a Fuji/astro pcb 0.5m conveyor? pref from the UK or europe the length of the belts are approx 630mm and 6mm wide, flat with bumps on bottom side
Electronics Forum | Sun Jul 25 00:59:47 EDT 2010 | smellew
llew@SurfaceMountEngineering.com Sales@SurfaceMountEngineering.com Web: http://www.SurfaceMountEngineering.com
Electronics Forum | Mon Oct 06 18:24:34 EDT 2003 | pjc
what type of belt is it and what material is it? round belt, flat belt, etc... if its from a PCB transport conveyor or other PCB handling system, I recommend you contact the OEM. I have spliced belts before- rubber round belt off old Fuji loader and
