Electronics Forum | Sat Aug 18 10:06:05 EDT 2012 | cyber_wolf
There is no defined method that I am aware of. If your bulbs are old replace them. Other than that adjust the gain and offset until there is clear definition on the edges of the components. Keep an eye on the dump box.If the dump box stays relatively
Electronics Forum | Wed May 09 15:36:09 EDT 2001 | cabjerk
Hi Everyone; Does anyone have any info on the fuji line monitor and how to dump the info to a file. Sense the line monitor only keeps 7 days worth of data, I would like to dump the info to a file (text,excel,access) everyday then compile as needed,
Electronics Forum | Thu Sep 02 19:22:08 EDT 2010 | fulldrawmike
seen it on a uni-mod many times. there is a muffler near that assy that if dirty will cause the air dump to back up and not exit out the muffler. if yours has one, remove it and see if it stops the table latch. it will be loud but it will let you k
Electronics Forum | Wed Feb 21 10:39:06 EST 2007 | russ
Contact practical components, they have masks and balls, I would not call it automated though. These are simply placing the mask over the part and dumping the balls on it then removing (brushing)the excess balls. I have run and reballed BGAs with ou
Electronics Forum | Fri Sep 03 08:25:30 EDT 2010 | remullis
I removed the muffler yesterday and still had the latch releasing issue, the latch was tight, however the table had some play in it. I adjusted the play out of the table, setup table zero and it fixed the problem. Same symptom as if the latch were lo
Electronics Forum | Wed Oct 10 08:13:03 EDT 2007 | cyber_wolf
Hi, What is the expected reject rate for capacitors on a CP643 machine. I estimate that we are dumping around 1 in 20 on average. I have played around with lighting levels,vision types etc. Nozzles are in mint condition. Can anyone offer any advice
Electronics Forum | Tue Sep 03 14:34:39 EDT 2002 | dragonslayr
All valuable insights are provided by the other posters to this thread. I'd like to add a bit more, if I may. Being environmental friendly is a must. I would not advocate dumping toxic metals to the sewer. In a past worklife, a steel mill, I was r
Electronics Forum | Sat Aug 09 12:37:40 EDT 2003 | cyber_wolf
Hello all, I am just curious as to the recovery # people are using on their Fuji chipshooters. One of my co-workers insist that we should run on E-stop. I tell him that we should run on 2 or 3 times and operators should be expected to watch the dump
Electronics Forum | Mon May 24 12:43:41 EDT 2004 | cyber_wolf
I have worked with Fuji turret machines for several years. I highly recommend them.They are mechanically superb. They very very rarely break. The only draw back from Fuji in my experience is the knowledge of the guys you get when you call the service
Electronics Forum | Fri Apr 02 11:18:02 EST 1999 | Scott McKee
| | We've been using a newly installed DI re-circulating system. | | It's been a big headache. Mostly understanding what causes our resistivity to be unpredictable. I think I've got a handle on that part now. The system consists of a Carbon,HMR(cheal
