Electronics Forum | Tue May 24 11:07:07 EDT 2005 | pr
Check "WP Sales" or "SMT Research", I know they have Fuji replacement parts like nozzles etc. I suspect they have feeder parts as well. good luck, pr
Electronics Forum | Wed Jul 26 14:40:28 EDT 2006 | FredC
I just checked a hand full of scrap nozzles and the scuffing is usually on the right or left of the needle. If you have the cross pin facing you and looking down on the nozzle most of the scuffing or wear was on the left side, sometimes on both sides
Electronics Forum | Wed Sep 22 20:57:46 EDT 1999 | JAX
| | Question for you SMT guru's out there. | | | | What is the best way to support boards on Fuji's CP6 machine's x-y table...particularly for 2nd side SMT where the support side already has parts... I am toying around with the following methods: |
Electronics Forum | Mon Sep 14 11:45:08 EDT 1998 | John McMasters
Has anyone used Fuji's rubber tip nozzles for the IP3? Are they O-ring type or suction cup? I'm having trouble picking up Ompacs due to the top of the part not consistently being flat. Any actual experience with these $1100 nozzles would be appreci
Electronics Forum | Mon Jun 11 14:36:21 EDT 2007 | shrek
Greeting all! Welcome to my swamp. It�s not much, but I call it home. I am new to this blog site but have a myriad of problems with my Fuji CP 6. I may not be the sharpest ogre in the land, but would appreciate a little help from my little donkey
Electronics Forum | Wed Sep 17 11:13:06 EDT 2008 | daxman
You had mentioned that your volumes will be low? How about the mix? will you be changing over to different products a lot? How many different products will you be running? Will feeder setups be done by the operators or will you have a another departm
Electronics Forum | Fri Apr 25 16:12:38 EDT 2003 | hruiz
Hello everyone, could you advise me how to select smt EQUIPMENT for low volume high mix??. Before we run high volume production but now we are changing to low to medium volume, we�re using fuji CP6 and universal GSM, and righ our best time for a
Electronics Forum | Tue Oct 12 10:24:22 EDT 2004 | sdsmt
i worked with cp6s in 1995 and 1996. we always had missing part problems that was machine related. we had to inspect every board for missing parts. it was a disaster, imho, but i expect a chipshooter to consistently load chips. otherwise, it was
Electronics Forum | Mon Sep 06 14:01:08 EDT 1999 | KEVIN SIMPSON
| | We are using some Fuji machines and have trouble picking parts up from damaged or mis-adjusted feeders. When I was working with Panasonic machines I was able to buy a feeder alignment jig from them to align the pick spot in the feeder, but Fuji d
Electronics Forum | Fri Oct 26 08:40:26 EDT 2007 | mulder0990
Doing the research on the feeder jigs, I have found that certian jigs are not used in most places. I am hoping that some people with the different jigs can post their feedback on the jigs they have. I have been told that some of the 'cheaper' manuf
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Building A, Jiepeng Square, Fuyong
Shenzhen, 30 China
Phone: 0755-33578694